Development of an innovative external (in air) Particle Induced Gamma-ray Emission method for rapid non-destructive determination of isotopic composition of boron in "As received" boron based ceramic neutron absorbers

Sk Wasim Raja,Vishal Sharma,Sudeep Kumar Samanta,Raghunath Acharya,Tammana Src Murthy,Sanjib Majumdar,Pradeep Kumar Pujari
DOI: https://doi.org/10.1016/j.aca.2022.339686
2022-04-15
Abstract:Boron is an important element in nuclear reactor technology due to its high neutron absorption cross section of 10B isotope. Isotopic composition of B (IC, 10B/11B atom ratio) determination in finished neutron absorbers is a necessity under chemical quality control (CQC). We report an innovative greener method for rapid and non-destructive approach of isotopic composition determination of B in "as received" boron based ceramic neutron absorbers including boron carbides and hexa-borides by external (in air) Particle Induced Gamma-ray Emission (PIGE) using 3.5 MeV proton beam. It involves irradiation of "as received" powder samples wrapped in a thin Mylar film and measurement of prompt gamma rays at 429, 718 and 2125 keV from 10B(p,αγ)7Be, 10B(p,p'γ)10B and 11B(p,p'γ)11B, respectively, using a HPGe detector system. The method was standardized with natural and enriched B4C powders. For validation, the results of isotopic composition obtained from "as received" samples were compared with that obtained from pellet samples using both external and vacuum chamber PIGE methods. IC values obtained for natural to 10B enriched samples (19.8-67 atom % of 10B) are very encouraging with 1-2% and 0.3-0.7% uncertainties from single and replicate sample experiments. The method is truly non-destructive as the samples can be returned back as such after the experiment as they are not radioactive. Compared to existing PIGE method for isotopic composition of B, the developed method keeps promise for wide applications as it is simple, sensitive and rapid and it does not require vacuum, pellet preparation with a binder, exact mass of the sample and beam current measurement.
What problem does this paper attempt to address?