Using Micromachined Molds, Partial-curing PDMS Bonding Technique, and Multiple Casting to Create Hybrid Microfluidic Chip for Microlens Array

Pin-Chuan Chen,Ren-Hao Zhang,Liang-Ta Chen

DOI: https://doi.org/10.3390/mi10090572

IF: 3.4

2019-08-29

Micromachines

Abstract:In a previous study, we presented a novel manufacturing process for the creation of 6 × 6 and 8 × 8 microlens arrays (MLAs) comprising lenses with diameters of 1000 μm, 500 μm, and 200 μm within an area that covers 10 mm × 10 mm. In the current study, we revised the manufacturing process to allow for the fabrication of MLAs of far higher density (15 × 15 and 29 × 29 within the same area). In this paper, we detail the revised manufacturing scheme, including the micromachining of molds, the partial-curing polydimethylsiloxane (PDMS) bonding used to fuse the glass substrate and PDMS, and the multi-step casting process. The primary challenges that are involved in creating MLAs of this density were ensuring uniform membrane thickness and preventing leakage between the PDMS and glass substrate. The experiment results demonstrated that the revised fabrication process is capable of producing high density arrays: Design I produced 15 × 15 MLAs with lens diameter of 0.5 mm and fill factor of 47.94%, while Design II produced 29 × 29 MLAs with lens diameter of 0.25 mm and fill factor of 40.87%. The partial-curing PDMS bonding system also proved to be effective in fusing PDMS with glass (maximum bonding strength of approximately six bars). Finally, the redesigned mold was used to create PDMS membranes of high thickness uniformity (coefficient of variance <0.07) and microlenses of high lens height uniformity (coefficient of variance <0.15).

chemistry, analytical,nanoscience & nanotechnology,instruments & instrumentation,physics, applied