Abstract:Glass is a hard and brittle insulating material that is widely used in optics, biomedicine, and microelectromechanical systems. The electrochemical discharge process, which involves an effective microfabrication technology for insulating hard and brittle materials, can be used to perform effective microstructural processing on glass. The gas film is the most important medium in this process, and its quality is an important factor in the formation of good surface microstructures. This study focuses on the gas film properties and their influence on the discharge energy distribution. In this study, a complete factorial design of experiments (DOE) was used, with three factors and three levels of voltage, duty cycle, and frequency as the influencing factors and gas film thickness as the response for the experimental study, to obtain the best combination of process parameters that would result in the best gas film quality. In addition, experiments and simulations of microhole processing on two types of glass, quartz glass and K9 optical glass, were conducted for the first time to characterize the discharge energy distribution of the gas film based on the radial overcut, depth-to-diameter ratio, and roundness error, and to analyze the gas film characteristics and their effects on the discharge energy distribution. The experimental results demonstrated the optimal combination of process parameters, at a voltage of 50 V, a frequency of 20 kHz and a duty cycle of 80%, that achieved a better gas film quality and a more uniform discharge energy distribution. A thin and stable gas film with a thickness of 189 μm was obtained with the optimal combination of parameters, which was 149 μm less than the extreme combination of parameters (60 V, 25 kHz, 60%). These studies resulted in an 81 μm reduction in radial overcut, a roundness error reduced by 14, and a 49% increase in the depth–shallow ratio for a microhole machined on quartz glass.

Study on the stability of gas film in electrochemical discharge machining of ultra-white glass micro array holes

Micro Array Hole Formation in Glass Using Electrochemical Discharge Machining

Study of Gas Film Characteristics in Electrochemical Discharge Machining and Their Effects on Discharge Energy Distribution

Electrochemical discharge machining of microchannels in glass using a non-Newtonian fluid electrolyte

A green and precision compound machining method for glass micro components – Ultrasonic assisted electrochemical discharge grinding with multi-hole tube electrode

Experimental and numerical investigations into the fabrication of alumina ceramic surface microchannel by electrochemical discharge machining

Electrochemical discharge machining of a high-precision micro-holes array in a glass wafer using a damping and confinement technique

Review—Electrochemical Discharge Machining: Gas Film Electrochemical Aspects, Stability Parameters, and Research Work

Experimental Study on Ultrasonic Vibration-Assisted WECDM of Glass Microstructures with a High Aspect Ratio

On the Machinability and Formation of Gas Film Thickness in ECDM of Silica based Pyrex Glass

Investigation of the Material Removal Mechanism in Electrochemical Discharge Drilling Using a High-Speed Rotating Helical Tool-Electrode

Computational modelling and experimental investigation of micro-electrochemical discharge machining by controlling the electrolyte temperature

Discharge Characteristics and Mechanisms of Electrolytic Discharge Processing by Jet Mask

Study on technology of zinc oxide piezoelectric thin film device with surface micromachining substrate

Chain discharging behavior induced by gas film expansion and its influence on the electrochemical discharge machining (ECDM) process

Electrochemical oxidation assisted micromachining of glassy carbon substrate

Insights into the high-speed electrochemical discharge drilling for film cooling hole: Machining phenomena, morphological evolution, and visualize simulation

Study on the material removal mechanism and the exit breakage of ultrasonic vibration-assisted grinding for microcrystalline glass

Review of electrochemical discharge machining technology for insulating hard and brittle materials

A Hybrid Process of Electrochemical Discharge Machining (ECDM) and High-Speed Milling (HSM) on Quartz Glass

An Investigation into Laser-Assisted Electrochemical Discharge Machining of Transparent Insulating Hard-Brittle Material