Abstract:During petroleum drilling, the reciprocating motion in the seal device leads to piston and sleeve wear, which may cause leakage of the sealing medium. Selecting appropriate materials for the piston and sleeve, along with surface modifications, can effectively prolong the seal service life of the seal. The friction and wear properties of piston and sleeve pairs of different materials in a metal sealing device were simulated by the laboratory "pin-on-block" reciprocating friction test. Pins made of 45# steel, 35CrMo, and 20Cr13 were used to simulate piston bulges, while 35CrMo samples were used to simulate sleeves. Additionally, the influence of DLC (diamond-like carbon) coating and QPQ (Quench–Polish–Quench) nitriding on the wear resistance of the materials was studied. Based on this, the friction and wear properties, along with the wear mechanism of different material pairs, were analyzed. The results show that the friction coefficient curves of the three piston base materials and the 35CrMo sleeve are similar, and the friction coefficient of 45# steel is lower than that of 35CrMo and 20Cr13 at the initial stage. The DLC surface coating exhibited the best anti-wear performance, with the lowest friction coefficient, minimal wear, and the most stable friction coefficient. Surface QPQ nitriding treatment can also improve the wear resistance of the base material. However, due to the oxide formed during nitriding being prone to flaking, the friction coefficient fluctuates significantly at the initial stage of testing, and its anti-wear performance was inferior to that of the DLC coating. This study on material pairing and surface modification provides theoretical support for material selection and surface modification design of pistons and sleeves in oil drilling sealing devices.

Tribological Behavior of Hydraulic Cylinder Coaxial Sealing Systems Made from PTFE and PTFE Compounds

Theoretical and Experimental Research Concerning the Friction Forces Developed in Hydraulic Cylinder Coaxial Sealing Systems Made from Polymers

Optimum Design of Coaxial Hydraulic Sealing Systems Made from Polytetrafluoroethylene and Its Compounds

Tribological Properties of Seals in Integrated Transmission of Vehicle

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Experimental investigation on frictional behavior and sealing performance of different composites for seal application

Tribological Behavior of Reinforced PTFE Composites and Un-Reinforced Polyketone-Based Materials against Coated Steel

A study on improving friction and wear performance of bearing bush in radial piston hydraulic motor

Impact of lubrication on the tribological behaviour of PTFE composites for guide rings application

Tribological behavior of PTFE/Nomex/phenolic composite lubricant under cold forming condition in the bearing assembly process

Tribological evaluation of thermoplastic polyurethane-based bearing materials under water lubrication: Effect of load, sliding speed, and temperature

Tribological Interaction between Piston and Cylinder of a Model High Pressure Hydraulic Pump

Piston Rod Coating Material Study of Reciprocating Sealing Experiment Based on Sterling Seal

Tribocorrosion Behavior of Several Corrosion-resistant Alloys Sliding Against CF-PEEK: Application for Hydraulic Valve in Seawater

WEAR RESISTANCE OF SELECTED ANTI-WEAR COATINGS USED IN MULTI-MATERIAL COMPOSITE HYDRAULIC CYLINDERS

Influence of Counter Surface Roughness and Lay on the Tribological Behaviour of Self-Lubricating Bearing Materials in Dry Sliding Conditions at High Contact Pressures

Study on Friction and Wear Performance of Sliding Metal Seal Materials Under Reciprocating Motion

Tribological and physical properties of PTFE-NBR self-lubricating composites under water lubrication

Polymeric Tribotechnical Composites on the Basis of Polytetrafluoroethylene and Complex Fillers

Sealing performance assessments of PTFE rotary lip seals based on the elasto-hydrodynamic analysis with the modified archard wear model

Optimization and tribological performance of PEEK based composite coatings reinforced with PTFE for friction pairs of aviation hydraulic pumps