Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

The Behavior of Cement-Treated Crushed Rock Material Under the Cyclic-Loading Test with Multiple Amplitude of Applied Strain

Effects of Moisture Content on the Cyclic Behavior of Crushed Tuff Aggregates by Large-Scale Tri-Axial Test

Study on Flexural Fatigue Life of Ultra-High Toughness Cementitious Composites under Constant Amplitude Cyclic Loading

Low-Cycle Fatigue Test of Circular Concrete Filled Tubular Columns

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control

Study on the strain of composite cement soil under cyclic loading

Experimental Study on Rock Strength and Deformation Characteristics Under Triaxial Cyclic Loading and Unloading Conditions

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Experimental Study On Particle Breakage Of Carbonate Gravels Under Cyclic Loadings Through Large-Scale Triaxial Tests

Test Study on Dynamic Deformation Behavior of Soft Rock-Concrete Sample under Cyclic Loading

Experimental study on three-point-bending characteristics of hard and soft rock-like materials under different loading rates

Experimental Study on Effects of Cyclic Loading Paths on Cracking Behavior and Fracture Characteristics of Granite

A review of experimental and theoretical research on the deformation and failure behavior of rocks subjected to cyclic loading

The strain characteristics and corresponding model of rock materials under uniaxial cyclic load/unload compression and their deformation and fatigue damage analysis

Experimental investigation of the dynamic mechanical properties of concrete under different strain rates and cyclic loading

Experimental Investigation on the Fatigue Mechanical Properties of Intermittently Jointed Rock Models Under Cyclic Uniaxial Compression with Different Loading Parameters

Response of concrete to dynamic elevated-amplitude cyclic tension

Numerical simulation of micro crack evolution and failure modes of limestone under uniaxial multi-level cyclic loading

Investigation of fatigue failure and energy characteristics of rock exposed to complicated stress disturbance paths: Cyclic stress amplitude effect

Mechanical Performance and Void Structure Change of Foamed Cement Paste Subjected to Static and Cyclic Loading under Plane Strain Conditions