Abstract:To reveal the deformation mechanism during tunneling in deep soft ground, triaxial unloading confining pressure tests and triaxial unloading creep tests were carried out on sandy mudstone specimens to study the dilatancy and fracturing behavior of soft rock. In the triaxial unloading confining pressure tests, the stress path and different unloading rates were considered to reflect the unloading characteristics of the excavation methods. The unloading rate effects and the rock damage evolution law are studied. The following conclusions are obtained from the results. Firstly, when the unloading rate is smooth, the peak strengths and deviatoric stress–strain curves under the unloading condition are close to those under the conventional loading condition. Secondly, the post-peak brittle characteristics are more apparent with the increasing unloading rates. Thirdly, the soft rock undergoes five deformation and failure regimes of elasticity, pre-peak unloading damage–dilatancy, post-peak brittle drop, linear strain softening and residual perfect plasticity under quasi-static smooth unloading of mechanized excavation which is mainly focused on in this study. Fourthly, the damage evolution law at the pre-peak damage–dilatancy stage follows an exponential function. Fifthly, during the post-peak stages, multistage microfractures are initiated, propagated and finally coalesced forming a shear-fragmentation band with a certain thickness, accompanied by significant volumetric dilatancy. In the triaxial unloading creep tests, multistep unloading of the confining pressure was applied, while the axial pressure was kept constant. The results show that when the deviatoric stress is larger and the experienced creep time is longer, the unloading effect and creep characteristics become more apparent accompanied with obvious lateral dilatancy, eventually leading to significant creep–dilatancy. The progressive failure with time is caused by the damage accumulating with time-dependent crack expansion, which can be called as ‘time-dependent damage and fracturing’. The reasons for the above evolution process are presented, then the deformation mechanism of soft rock is revealed. The soft rock deformation mainly consists of two parts. One part is the pre-peak damage–dilatancy and post-peak fracture–bulking produced at the excavation unloading instant. The other part is creep–dilatancy caused by time-dependent damage and fracturing in a period of time after excavation. The above-mentioned results of damage, dilatancy and fractures evolution process are in good agreement with the in situ monitoring results and previous studies about the surrounding rock convergence, fracturing and EDZ (excavation damaged zone) development.

Experimental study on three-point-bending characteristics of hard and soft rock-like materials under different loading rates

Biaxial Creep Test Study on the Influence of Structural Anisotropy on Rheological Behavior of Hard Rock

A Method for Evaluating the Maximum Bending Degree of Flexural Toppling Rock Masses Based on the Rock Tensile Strain-Softening Model

Investigation Into Deformation and Failure Characteristics of the Soft-Hard Interbedded Rock Mass Under Multiaxial Compression

Influences of layer combination on fracture behaviour of soft–hard interbedded rock layers using three-point-bending test

Experimental mechanical strength and deformation characteristics of deep damaged–fractured rock

A study of rock response to failure in the context of the bending properties and comparison with uniaxial tensile and compression behaviour

Study on multi-scale damage and failure mechanism of rock fracture penetration: experimental and numerical analysis

Experimental Investigation of Pre-Flawed Rocks under Dynamic Loading: Insights from Fracturing Characteristics and Energy Evolution

Experimental and numerical investigation of crack propagation and dynamic properties of rock in SHPB indirect tension test

Study on Staged Damage Behaviors of Rock-like Materials with Different Brittleness Degrees Based on Multiple Parameters

Experimental investigations of the dynamic mechanical properties and fracturing behavior of cracked rocks under dynamic loading

Experimental Study on the Dilatancy and Fracturing Behavior of Soft Rock Under Unloading Conditions

Experimental investigation of the strain rate effect on crack initiation and crack damage thresholds of hard rock under quasi-static compression

Mechanical properties of rock under uniaxial compression tests of different control modes and loading rates

Rate- and Normal Stress-Dependent Mechanical Behavior of Rock Under Direct Shear Loading Based on a Bonded-Particle Model (BPM)

Experimental Study of Energy Evolution at a Discontinuity in Rock under Cyclic Loading and Unloading

Experimental and numerical investigation on the mechanical responses and cracking mechanism of 3D confined single-flawed rocks under dynamic loading

A Numerical Study of the Mechanical Behavior of Jointed Soft Rocks under Triaxial Loading Using a Bonded Particle Model

Experimental Study on the Effect of Brittleness on the Dynamic Mechanical Behaviors of the Coal Measures Sandstone

Evaluation of Rock Brittleness Index under Dynamic Load