Experimental study on three-point-bending characteristics of hard and soft rock-like materials under different loading rates
Da Huang,Yang Liu,Yunyun Yang,Zhao Li,Qiujie Meng
DOI: https://doi.org/10.1007/s12517-021-08284-9
2021-09-01
Arabian Journal of Geosciences
Abstract:Bending failure is a common failure mode of layered rock mass. Making clear the mechanical behaviors and energy evolution characteristics of layered rock mass, it is beneficial to prevent geological disasters caused by the bending deformation of layered rock mass. In this study, the mechanical behaviors and energy evolution characteristics of hard and soft rocks by conducting the three-point-bending (TPB) test with different loading rates were investigated. The results show that as the loading rate increases, both the peak load of hard and soft rock increases, the peak displacement of hard rock decreases, while the peak displacement of soft rock increases. The horizontal crack width at the bottom of the sample of hard rock is greater than that of soft rock, but the instantaneous crack widths show opposite results. Both the failure pattern of hard rock and soft rock are the typical tensile fracture, yet the fracture surface of hard rock is denser and smoother than that of soft rock. For hard rock, the total input energy, elastic energy, and dissipated energy increase with the increase of loading rate. For soft rock, however, the total input energy and elastic energy increases, while the dissipated energy decreases. Under the TPB test, the peak load, displacement, instantaneous crack width, total input energy, elastic energy, and dissipated energy of both hard rock and soft rock present linear relationships with the common logarithm of the loading rate.
geosciences, multidisciplinary