Abstract:A series of dynamic axial tensile tests were performed on concrete and its three components using a servo-hydraulic testing machine. The dynamic mechanical properties of approximately 200 specimens were tested under a dynamic load at strain rates that ranged from 10 to 10(-2) s(-1), different initial static loads, and cyclic variable-amplitude loads with different frequencies. The results indicated the following: 1) tensile strength is sensitive to strain rate in all these materials and the rate sensitivity of strength for concrete was close to the composite material with the lowest sensitivity factor k; 2) the elastic modulus is less sensitive to strain rate than strength in all the materials. The rate sensitivity of the modulus for concrete was close to its component material with the lowest sensitivity factor m. The interfacial transition zone (ITZ) had the highest m among the composites; 3) the stress-strain relation for mortar is almost completely linear before peak stress. In contrast, the stress-strain relations of the concrete, granite, and interface appear nonlinear when the stress is set at more than approximately 50% of the peak value, and the nonlinear section showed a linear trend with increasing strain rate; 4) an initial static load within certain limits increased the dynamic tensile strength. The critical initial static loads for the mortar, granite, interface, and concrete were 70%, 50%, 50%, and 30%, respectively; and 5) the cyclic loading history had the least influence on the mortar and the most influence on the interface. The influence of fatigue damage decreased when the loading frequency increased.

Response of concrete to dynamic elevated-amplitude cyclic tension

Uniaxial Tensile Properties of Concrete under the Action of Cyclic Variable Amplitude Load

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

Experimental study on concrete under dynamic tensile loading

Low-Cycle Fatigue Test of Circular Concrete Filled Tubular Columns

Flexural behavior of concrete-filled circular steel tubes under high-strain rate impact loading

Experimental investigation of the dynamic mechanical properties of concrete under different strain rates and cyclic loading

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control

Failure mechanism of concrete in dynamic loading

Dynamic Properties of Concrete in Direct Tension

Large-Beam Tests on Mechanical Behavior of Dam Concrete under Dynamic Loading

Effect of initial static load on the rate-sensitive behavior of concrete in compression

Uniaxial Compressive Properties of Concrete under the Cyclic Load

Strength and Deformation Characteristics of Concrete under Dynamic Biaxial Loading

Dynamic Tensile Properties of Concrete under Different Environments

Dynamic Evolution of Concrete Strength Grades: Insights Across Different Ages and Strain Rates

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

Effect of Prestatic Loading on Dynamic Tensile Strength of Concrete under High Strain Rates

Influence of Initial Static Stress on the Dynamic Properties of Concrete

Experimental Study on Dynamic Axial Tensile Mechanical Properties of Concrete and Its Components

Time-varying damage evolution of concrete under cyclic disturbance loading- an experimental observation utilizing AE and DIC