Abstract:The tensile strength of concrete material increases with the strain rate. The dynamic tensile strength of concrete material is usually obtained by conducting laboratory tests such as direct tensile test, spall test or splitting test (Brazilian test). It is commonly agreed now that the DIF obtained from dynamic impact test is affected by lateral inertia confinement. Therefore, those derived directly from testing data do not necessarily reflect the true dynamic material properties. The influence of the lateral inertia confinement, however, is not straightforward to be quantified in laboratory tests. Moreover, concrete is a heterogeneous material with different components, but is conventionally assumed to be homogeneous, i.e. cement mortar only, in most previous experimental or numerical studies. The aggregates in concrete material are usually neglected owing to testing limitation and numerical simplification. In the present study, a mesoscale concrete material model consisting of cement mortar, aggregates and interfacial transition zone (ITZ) is developed to simulate direct tensile tests and to study the influences of the lateral inertia confinement and heterogeneity on tensile strength of concrete material with respect to strain rates between 1/s and 150/s. The commercial software AUTODYN with user provided subroutines is used to perform the numerical simulations of SHPB tests. The model is verified by testing data obtained by others. Numerical simulation results indicate that the lateral inertia confinement contributes to the dynamic increase factor (DIF) of concrete material tensile strength. The lateral inertia confinement effect is specimen size and strain rate dependent. Based on the numerical results, discussions on the relative contributions from the lateral inertia confinement and the material strain rate effect on DIF of concrete material tensile strength are made. Empirical relations are proposed to remove the influence of the lateral inertia confinement in dynamic impact tests on dynamic concrete material strength. The effect of aggregates inside the concrete specimen on its dynamic strength is also investigated. The results demonstrate that it is very important to include aggregates in experimental and numerical studies of concrete material dynamic strength, otherwise significant inaccuracy might be induced.

Dynamic Properties of Concrete in Direct Tension

Dynamic Tensile Properties of Concrete under Different Environments

Strain-rate sensitivity of concrete: Influence of moisture content

Dynamic Properties of Plain Concrete in Triaxial Stress State

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Experimental study on concrete under dynamic tensile loading

Dynamic Tensile Experiments of Concrete and Its Data Analysis Method

Dynamic Properties of Concrete under Severe Environmental Condition

STRAIN RATE EFFECTS ON THE BEHAVIOR OF CONCRETE AND THE SEISMIC RESPONSE OF CONCRETE STRUCTURES

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

Strength of Concrete Filled Steel Tubes under High-Strain Rate Loading

Experimental characterization of concrete in dynamic tension

Numerical analysis of concrete material properties at high strain rate under direct tension

Effect of initial static load on the rate-sensitive behavior of concrete in compression

Influence of Initial Static Stress on the Dynamic Properties of Concrete

Strength and Deformation Characteristics of Concrete under Dynamic Biaxial Loading

Failure mechanism of concrete in dynamic loading

Strain-Rate Sensitivity of Concrete: Influence of Temperature

EFFECT OF STRAIN RATE ON THE BIAXIAL COMPRESSIVE BEHAVIOR OF CONCRETE

Study on Axial Tensile Strain Rate Effect on Concrete Based on Experimental Investigation and Numerical Simulation

Experimental investigation of the dynamic mechanical properties of concrete under different strain rates and cyclic loading