Abstract:A series of dynamic axial tensile tests were performed on concrete and its three components using a servo-hydraulic testing machine. The dynamic mechanical properties of approximately 200 specimens were tested under a dynamic load at strain rates that ranged from 10 to 10(-2) s(-1), different initial static loads, and cyclic variable-amplitude loads with different frequencies. The results indicated the following: 1) tensile strength is sensitive to strain rate in all these materials and the rate sensitivity of strength for concrete was close to the composite material with the lowest sensitivity factor k; 2) the elastic modulus is less sensitive to strain rate than strength in all the materials. The rate sensitivity of the modulus for concrete was close to its component material with the lowest sensitivity factor m. The interfacial transition zone (ITZ) had the highest m among the composites; 3) the stress-strain relation for mortar is almost completely linear before peak stress. In contrast, the stress-strain relations of the concrete, granite, and interface appear nonlinear when the stress is set at more than approximately 50% of the peak value, and the nonlinear section showed a linear trend with increasing strain rate; 4) an initial static load within certain limits increased the dynamic tensile strength. The critical initial static loads for the mortar, granite, interface, and concrete were 70%, 50%, 50%, and 30%, respectively; and 5) the cyclic loading history had the least influence on the mortar and the most influence on the interface. The influence of fatigue damage decreased when the loading frequency increased.

Strength and Deformation Characteristics of Concrete under Dynamic Biaxial Loading

Biaxial Behaviour Of Plain Concrete Subjected To Dynamic Compression With Constant Lateral Stress

Dynamic Behaviour of Concrete in Biaxial Compression

EFFECT OF STRAIN RATE ON THE BIAXIAL COMPRESSIVE BEHAVIOR OF CONCRETE

DYNAMIC STRENGTH AND DEFORMATION OF CONCRETE IN TRIAXIAL STRESS STATES

Dynamic Biaxial Compressive Strength and Fracture Pattern of Concrete with Constant Confining Pressure

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Dynamic Properties of Plain Concrete in Triaxial Stress State

Experimental Study on the Uniaxial Dynamic Compression Properties of Concrete

Experimental study on biaxial dynamic equal ratio load compressive damage of concrete

Dynamic Properties of Concrete in Direct Tension

Behavior of Concrete Under the Triaxial Compression

Experimental Study on Dynamic Axial Tensile Mechanical Properties of Concrete and Its Components

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control

Experimental study on concrete under dynamic tensile loading

Experimental Study on Dynamic Biaxial Tension-Compression Properties of Hydraulic Concrete

Effect of Prestatic Loading on Dynamic Tensile Strength of Concrete under High Strain Rates

Behavior of Concrete under Nonproportional Biaxial Fatigue Stresses with One Constant

Dynamic Tensile Experiments of Concrete and Its Data Analysis Method

Effect of initial static load on the rate-sensitive behavior of concrete in compression

A Note on the Flexural Behavior of Concrete under Different Loading Rates