Abstract:This article focuses on realizing wideband compartment shielding in the shielding can packages of miniaturized high-speed chip modules and circuits. Because the conventional diaphragms with a low profile are difficult to cope with the high-order mode interference and evanescent wave interference, a new “meta-diaphragm,” which is based on the single-negative (SNG) metamaterial, is proposed to address these inherent problems. It is demonstrated that benefitting from the large propagation attenuation introduced by the proposed meta-diaphragm, a good shielding performance can be achieved at the first higher order resonance mode. Moreover, by elaborately embedding resistors in the meta-diaphragm, the additional interferences at other resonance frequencies can be significantly suppressed. Furthermore, the structure of the meta-diaphragm is optimized with two approaches: evolving from the single-band SNG structure to the double-band one and integrating with the parasitic patches. The two approaches enable its independent controlling ability at different frequency ranges and enhancement of low-frequency shielding performance. Based on the proposed technique, an experiment is implemented to suppress the resonance-dominated interference between the passive traces in a shielding can. The result agrees well with those from theoretical prediction. The final experimental shielding can’s profile and width are 5 and 20 mm, respectively; the meta-diaphragm’s profile is only 1.5 mm, i.e., < 1/3 of shielding can’s profile, and its electrically length is only 3 mm, i.e., $0.1\lambda _{0}$ at 10 GHz, and the measured (simulated) meta-diaphragm can significantly suppress radio frequency interference (RFI) within 10.2–17 GHz (10–16.9 GHz) and realize $< -33.5$ dB ( $< -40$ dB) coupling within 100 kHz–18 GHz (dc-to-20 GHz). The miniaturized dimension and wideband results indicate that our proposed technique could meet the compartment shielding requirement of a series of miniaturized packages in the practical radio frequency (RF) chip modules and circuits.

GaN 2DEG Varactor-Based Impulse Suppression Module for Protection Against Malicious Electromagnetic Interference

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

Improved surge protection of flip-chip gallium nitride-based HEMTs by metal-semiconductor-metal two-dimensional electron gas varactor

A Gallium Nitride Integrated Power Module with Ultra-low Parasitic Inductances and Thermal Resistance

A GaN-based metal-semiconductor-metal planar inter-digitated varactor

A GaN HEMT Integrated Power Module with Silver Sintering Processes

Improvement on Diode String Structure for 65-Nm RF ESD Protection

Multi-channel GaN varactors and their current conduction mechanisms

Wideband Compartment Shielding Technique for Miniaturized Packages Based on Electrically Small Single-Negative Meta-Diaphragm

Capacitive Diaphragm for Compartment Shielding in the Fifth-Generation Radio Frequency Systems

Device Modeling of RF Varactor Diodes for Adjustable Microwave Reflectivity in Active Frequency Selective Surfaces

Annealing-Dependent Breakdown Voltage and Capacitance of Gallium Oxide-Based Gallium Nitride MOSOM Varactors

Crosstalk Suppression in Monolithic GaN Devices Based on Inverted E -Field Decoupling

Effects of Depletion Region in GaN-based Metal-Semiconductor-metal Planar Inter-Digitated Varactor

A Novel Bidirectional AlGaN/GaN ESD Protection Diode

Integrated High-Speed Over-Current Protection Circuit for GaN Power Transistors

The DC Performance and RF Characteristics of GaN-Based HEMTs Improvement Using Graded AlGaN Back Barrier and Fe/C Co-Doped Buffer

E-Beam Fabricated Metal-Semiconductor-Metal (Msm) Varactor Based On Algan/Gan Hemt With Rectangular Gate Of 450nm

A Novel GaN:C Millimeter-Wave HEMT with AlGaN Electron-Blocking Layer

Study and Implementation of 600-V High-Voltage Gate Driver IC With the Common-Mode Dual-Interlock Technique for GaN Devices