Abstract:Tungsten is considered as the preferred material for plasma-oriented materials in fusion reactors, and its ultra-precision machining is a concern at present. However, the critical cutting depth for chip generation is an important parameter affecting the surface formation and removal behavior of materials in ultra-precision machining. Herein, the simulation analysis of nano-cutting tungsten using molecular dynamics (MD) was performed, and a new method to determine the minimum uncut chip thickness h min by identifying the atomic trajectory and calculating the relative coordinate value was proposed. Then, the effects rarely reported of the chip formation on the removal mechanism of tungsten were studied. The research showed that when the cutting depth h was 0.253 times of the cutting edge radius r, the critical cutting depth without chip was reached, namely h min. The increasing cutting temperature and stress led to the decrease of machined surface quality and the increase of subsurface damage with the rising in h/r. Meanwhile, the dislocation slip dominated by the direction of 1/2<111> was the main plastic deformation mechanism during cutting without chip, but the dislocation slip dominated by direction of <100> was main plastic deformation mechanism during processing with chip. The plastic deformation dominated by dislocation slip was also accompanied by the amorphization. The dislocation reaction from 1/2<111> dislocation to <100> dislocation occurred under both energy and geometry conditions. Moreover, the dislocations had more energy to expand and evolve as a result of thermal-activated effect induced by elevated cutting force and temperature, which increased the dislocation density, depth of subsurface damage layer, and the stress variation degree of the machined area with the enhancement of h min during cutting. This research provides a reference method for determining the minimum uncut chip thickness during material removal and is of significance for mastering the microscopic removal mechanism of tungsten.

On the mechanism of dislocation-dominated chip formation in cutting-based single atomic layer removal of monocrystalline copper

Controllable Diamond Cutting of Structured Surfaces with Subnanometric Height Features on Silicon

Molecular Dynamics Simulation of Subnanometric Tool-Workpiece Contact on a Force Sensor-Integrated Fast Tool Servo for Ultra-Precision Microcutting

Simulation of Chip Formation in High-Speed Hard Machining

Effect of Fluid Media on Material Removal and Subsurface Defects Evolution of Monocrystal Copper in Nano-Cutting Process

Quasicontinuum Simulations of Nano-cutting Process

Study on the atomic removal behavior and damage formation mechanism of nano cutting copper-nickel alloy with diamond tool

Effects of minimum uncut chip thickness on tungsten nano-cutting mechanism

Promoted grain refinement in tool-chip interface during ultrasonic elliptical vibration-assisted cutting of polycrystalline copper

Cutting of Graphite at Atomic and Close-to-Atomic Scale Using Flexible Enhanced Molecular Dynamics

Experimental Study on the Surface Integrity and Chip Formation in the Micro Cutting Process

Molecular Dynamics Analysis for the Influence of Corner Radius on Single Crystal Copper Nano-cutting Process

Atomic simulation study on the effect of defects on nano-cutting mechanism of single crystal copper

Nanocutting mechanisms of Cu50Zr50 amorphous alloy: A molecular dynamics simulation

Material removal mechanism of FCC single-crystalline materials at nano-scales: Chip removal & ploughing

Generation mechanism and dual-dynamics simulation of surface patterns in single-point diamond turning of single-crystal copper

Molecular dynamics simulation on formation mechanism of grain boundary steps in micro-cutting of polycrystalline copper

The interaction between grain boundary and tool geometry in nanocutting of a bi-crystal copper

New Mechanisms of Helical Dislocation Formation Via the Pinch-off Process Near a Nano-Inhomogeneity

Triple Effects of the Physicochemical Interaction between Water and Copper and Their Influence on Microcutting

Molecular Dynamics Simulation on Cutting Mechanism in the Hybrid Machining Process of Single-Crystal Silicon