Abstract:Active layer thickness variation in highly-doped amorphous indium-gallium-zinc oxide thin film transistors with molybdenum-chromium contacts is studied to reveal parametric dependencies under both channel length and gate-contact overlap length scaling. Devices with thickness variations from 5 nm to 30 nm, channel length variation from 3 µm to 100 µm and gate-contact overlap length variation from 1 µm to 10 µm were fabricated, characterized and analyzed. Analysis from a field effect transistor perspective show typical thickness variation trends where threshold voltage shifts positively, subthreshold slope improves and Ion/Ioff ratio increases as the active layer thickness is scaled down. Peculiar observations like extremely low saturation voltage, insensitivity towards channel length variations, two different slopes in the subthreshold region and peaks in the transconductance characteristics can be explained only by invoking the principle of Schottky transistor operation. Thinner devices exhibit high field Schottky operation with barrier lowering which causes monotonously increasing transconductance, while thicker devices show low field behavior with no barrier lowering signified by peaks with saturated behavior of transconductance. Channel length modulates this dependence of transconductance on thickness. Sensitivity towards gate-contact overlap length scaling increases with thickness. Devices with active layer thickness of 5 nm can withstand overlap length scaling up to 5 µm without transconductance degradation, while devices of 10 nm thickness can withstand overlap length scaling only upto 10 µm. Devices of 30 nm thickness show contact limited operation even at 10 µm overlap length. Conventional FET operating principles cannot explain these observations and the phenomenon of Schottky contact transistor operation has been invoked. The results point towards a thin borderline in low dimensional transistors, differentiating a FET from Schottky contact transistors, through a field dependent barrier lowering mechanism, which is modulated by active layer thickness, channel length and gate contact overlap length.

Influence of active layer thickness on the cut-off frequency of a-IGZO thin film transistors

Effect of active layer thickness variation on scaling response in a-IGZO thin film transistors under Schottky limited operation

Amorphous InGaZnO Thin-Film Transistors With Sub-10-nm Channel Thickness and Ultrascaled Channel Length

Influence of the Channel Layer Thickness on Electrical Properties of Indium Zinc Oxide Thin-Film Transistor

Effect of active layer thickness on device performance of a-LZTO thin-film transistors

Optimizing Length Scalability of InGaZnO Thin‐Film Transistors through Lateral Carrier Profile Engineering and Negative ΔL Extension Structure

Effect of high conductivity amorphous InGaZnO active layer on the field effect mobility improvement of thin film transistors

Specific contact resistivity reduction in amorphous IGZO thin-film transistors through a TiN/IGTO heterogeneous interlayer

Channel thickness effect on the performance of amorphous SiZnSnO semiconductor thin-film transistor with metal capping structure

Effect of the Active Channel Thickness Variation in Amorphous In-Zn-Sn-O Thin Film Transistor

Design and analysis of novel tri‐active layer channel amorphous‐IGZO thin‐film transistor

Influence of Oxygen Flow Rate on Channel Width Dependent Electrical Properties of Indium Gallium Zinc Oxide Thin-Film Transistors

Tri‐Layer Heterostructure Channel of a‐IGZO/a‐ITZO/a‐IGZO Toward Enhancement of Transport and Reliability in Amorphous Oxide Semiconductor Thin Film Transistors

The Influence of Channel Layer Thickness on the Electrical Properties of Zno Tfts

Enhancing IGZO Thin Film Transistor Scalability Through Tunneling Contact

Simulation study on the active layer thickness and the interface of a-IGZO-TFT with double active layers

Impact of layer thickness on the operating characteristics of In2O3/ZnO heterojunction thin-film transistors

Electrical Performance and Stability Improvements of High-Mobility Indium–Gallium–Tin Oxide Thin-Film Transistors Using an Oxidized Aluminum Capping Layer of Optimal Thickness

Impact of cation compositions on the performance of thin-film transistors with amorphous indium gallium zinc oxide grown through atomic layer deposition

35‐4: High‐Mobility and High‐Negative Bias Illumination Stress Stability Based on ITZO/IGZO Bilayer Thin Film Transistors