The investigation on microstructure evolution and mechanical behavior of extruded Mg-1.5Al-xLa-Mn (x=0.5, 1, 2wt%) alloys
Xiaoqiang Li,Qiyong Xu,Yangfan Liu,Jiantao Zhang,Dexue Liu,Qichi Le,Jinhui Wang,Yunpeng Zhu,Wenxin Hu
DOI: https://doi.org/10.1016/j.mtcomm.2024.108491
IF: 3.8
2024-03-01
Materials Today Communications
Abstract:In this study, the microstructure evolution and mechanical behaviour of Mg-1.5Al-xwt%La-Mn (ALaM-x) (x = 0.5, 1, and 2) alloys with low-cost were investigated. Microstructure analysis of the cast alloys revealed that the Al11La3 was preferentially precipitated, followed by Al2La, and finally Mg12La, as the Al/La ratio decreased. Nonetheless, the main precipitated phase in the alloy was Al11La3 phase, and it gradually coarsened and the content increased, with the increase of La content. The fine rod-like Al11La3 was broken and refined after extrusion, while the coarse Al11La3 was not completely broken, and aggregated unevenly within Mg matrix. As a result, the grain size of the alloys gradually increased, and the strength gradually decreased. When adding 0.5 wt%La, compared with pure Mg, the ALaM-0.5 alloy exhibited finer grain microstructure with an average size of 1.83 μm and a grain refinement rate of 90%; the corresponding tensile yield strength (TYS) and ultimate tensile strength (UTS) are 262.5±3.0 MPa and 275.0±2.4 MPa, with an increase rate of 124.7% and 52.1%, respectively. The calculation and analysis of strengthening mechanism showed that the high strength of the alloy was mainly attributed to fine-grained strengthening with an accounting for up to 42%. Besides, the inverse relationship between the square root of the reciprocal of grain size (d −1/2) and strain hardening exponents (n) was found in this study, and the precipitates were found to delay the weakening trend of strain hardening capacity with decreasing grain size.
materials science, multidisciplinary