Abstract:The high-strength aluminium alloys of the 7xxx series, which belong to the Al–Zn–Mg–Cu system, are known for their exceptional properties and are often used for applications where strength, fatigue resistance, stress corrosion resistance and wear resistance are required. The alloy EN AW-7175 requires an understanding of the precipitation process during solidification and cooling, where different phases are formed depending on the Zn/Mg ratio and cooling rate. Microstructural defects in the as-cast state affect the mechanical properties, prompting the investigation of La additions to refine the microstructure and improve the mechanical properties. In this study, the influence of La additions on the solidification and microstructure of the alloy EN AW-7175 in the as-cast state is investigated. Thermodynamic calculations, DSC and SEM analyses were performed. Samples with La additions (0.05–0.17 mass%) were compared with a reference sample (0 mass% La). La additives have only a minimal effect on the liquidus temperature and show minor differences in the solidus temperature in equilibrium calculations. The solidification interval decreases slightly compared to the reference sample, which is consistent with the Scheil simulations. The DSC results show reduced liquidus and solidus temperatures, while the solidification interval remains largely unchanged by the addition of La. The addition of La alongside Al 13 Fe 4 , Mg 2 Si and the eutectic α(Al) + σ[Mg(Zn, Cu, Al) 2 ] leads to the formation of two new La-based phases: Al 20 Cr 2 La and LaSi 2 . Al 20 Cr 2 La modifies the Al 45 Cr 7 phase and solidifies first, while LaSi 2 modifies Mg 2 Si. As the La content increases, the Mg 2 Si content decreases until it completely disappears at a La content of more than 0.1 mass%. On the contrary, according to the literature, the grain size increases somewhat with a higher La content.

Effect of La on microstructure and properties of AZ61 magnesium alloy

Effect of La and Nd on Microstructures and Mechanical Properties of AZ61 Wrought Magnesium Alloy

Effect of La Addition on the Microstructure and Mechanical Properties of Mg–6 Wt% Zn Alloys

Effect of La on the Mechanical Property and Corrosion Resistance of Az91d Magnisum Alloy

Influence of Lanthanum on the Microstructure, Mechanical Property and Corrosion Resistance of Magnesium Alloy

Effect of La Addition on Microstructure, Mechanical Behavior, Strengthening and Toughening Mechanisms of Cast Mg-Gd-Zn Alloy

Effects of La Addition on the Microstructure, Thermal Conductivity and Mechanical Properties of Mg-3Al-0.3Mn Alloys

Effects of La addition on the mechanical properties and thermal-resistant properties of Al–Mg–Si–Zr alloys based on AA 6201

Effect of La on the Corrosion Resistance of Az91d Magnesium Alloy in Nacl Aqueous Solution

The Evolution of Microstructure, Mechanical Properties and Fracture Behavior with Increasing Lanthanum Content in AZ91 Alloy

Influence of La additions on solidification and microstructure in the as-cast state of the aluminium alloy EN AW-7175

Effect of La on the Microstructures and Mechanical Properties of Al-5.4Cu-0.7Mg-0.6Ag Alloys

Effect of La Content on Microstructure, Thermal Conductivity and Mechanical Properties of Mg–4Al Magnesium Alloys

Effect of Lanthanum Addition on Grain Refinement and Mechanical Properties of Mg–9Li–3Al Alloy

Effect of Al Content on Microstructure, Thermal Conductivity, and Mechanical Properties of Mg–La–Al–Mn Alloys

The investigation on microstructure evolution and mechanical behavior of extruded Mg-1.5Al-xLa-Mn (x=0.5, 1, 2wt%) alloys

Effect Of La, Zr Micro-Alloying On The Microstructure And Mechanical Properties Of Al-5mg-0.2ti Alloy

Effects of Li Content on Microstructure and Mechanical Properties of As-Cast Mg?xLi?3Al?2Zn?0.5Y Alloys

Effects of Ca on Microstructure and Mechanical Properties of AZ61-1.2Y Magnesium Alloy

Effect of lanthanum content on microstructure and mechanical properties of Al-5Mg-2Si-0.6Mn alloy in squeeze casting

Effect of La/Nd ratio on microstructure and tensile properties of AZ91-RE alloys