Abstract:A fundamental challenge of the quantum revolution is to efficiently interface the quantum computing systems operating at cryogenic temperatures with room temperature electronics and media for high data-rate communication. Current approaches to control and readout of such cryogenic computing systems use electrical cables, which prevent scalability due to their large size, heat conduction, and limited bandwidth1. A more viable approach is to use optical fibers which allow high-capacity transmission and thermal isolation. A key component in implementing photonic datalinks is a cryogenic optical modulator for converting data from the electrical to the optical domain at high speed and with low power consumption, while operating at temperatures of 4 K or lower. Cryogenic modulators based on the electro-optic effect have been demonstrated in a variety of material platforms, however they are voltage driven components while superconducting circuits are current based, resulting in a large impedance mismatch. Here, we present the first demonstration of an integrated current-driven modulator based on the magneto-optic effect operating over a wide temperature range that extends down to less than 4 K. The modulator works at data rates up to 2 Gbps with energy consumption below 4 pJ/bit, and we show that this figure can be reduced to less than 40 fJ/bit with optimized design and fabrication. This modulator is a hybrid device, where a current-driven magneto-optically active crystal (cerium substituted yttrium iron garnet, or Ce:YIG) is bonded to a high-quality silicon microring resonator. Because of its potential for extremely low power consumption under cryogenic conditions, the class of magneto-optical modulators demonstrated here has the potential to enable efficient data links in large-scale systems for quantum information processing.

An integrated optical modulator operating at cryogenic temperatures

A low-power integrated magneto-optic modulator on silicon for cryogenic applications

Integrated thermo-optic phase shifters for laser-written photonic circuits operating at cryogenic temperatures

Cryogenic Photonic Readout Based on Thin-Film Lithium Niobate Mach–Zehnder Modulators

Cryogenic electro-optic interconnect for superconducting devices

Non-volatile Tuning of Cryogenic Optical Resonators

Cryogenic operation of silicon photonic modulators based on DC Kerr effect

Cryogenic electro-optic modulation in titanium in-diffused lithium niobate waveguides

High-performance integrated graphene electro-optic modulator at cryogenic temperature

A BaTiO3-Based Electro-Optic Pockels Modulator Monolithically Integrated on an Advanced Silicon Photonics Platform

Fast Thermo-Optical Modulators with Doped-Silicon Heaters Operating at 2 Μm.

High-speed programmable photonic circuits in a cryogenically compatible, visible-NIR 200 mm CMOS architecture

Cryogenic Electro-Optic Polarisation Conversion in Titanium in-diffused Lithium Niobate Waveguides

Multiplexed quantum transport using commercial off-the-shelf CMOS at sub-kelvin temperatures

Photonic link from single-flux-quantum circuits to room temperature

Cryogenic Optical-to-Microwave Conversion Using Si Photonic Integrated Circuit Ge Photodiodes

Photonic link from single flux quantum circuits to room temperature

Millikelvin temperature cryo-CMOS multiplexer for scalable quantum device characterisation

Pyroelectric Influence on Lithium Niobate During the Thermal Transition for Cryogenic Integrated Photonics

CMOS-compatible, piezo-optomechanically tunable photonics for visible wavelengths and cryogenic temperatures