Abstract:A fundamental challenge of the quantum revolution is to efficiently interface the quantum computing systems operating at cryogenic temperatures with room temperature electronics and media for high data-rate communication. Current approaches to control and readout of such cryogenic computing systems use electrical cables, which prevent scalability due to their large size, heat conduction, and limited bandwidth1. A more viable approach is to use optical fibers which allow high-capacity transmission and thermal isolation. A key component in implementing photonic datalinks is a cryogenic optical modulator for converting data from the electrical to the optical domain at high speed and with low power consumption, while operating at temperatures of 4 K or lower. Cryogenic modulators based on the electro-optic effect have been demonstrated in a variety of material platforms, however they are voltage driven components while superconducting circuits are current based, resulting in a large impedance mismatch. Here, we present the first demonstration of an integrated current-driven modulator based on the magneto-optic effect operating over a wide temperature range that extends down to less than 4 K. The modulator works at data rates up to 2 Gbps with energy consumption below 4 pJ/bit, and we show that this figure can be reduced to less than 40 fJ/bit with optimized design and fabrication. This modulator is a hybrid device, where a current-driven magneto-optically active crystal (cerium substituted yttrium iron garnet, or Ce:YIG) is bonded to a high-quality silicon microring resonator. Because of its potential for extremely low power consumption under cryogenic conditions, the class of magneto-optical modulators demonstrated here has the potential to enable efficient data links in large-scale systems for quantum information processing.

Cryogenic electro-optic interconnect for superconducting devices

Cryogenic Photonic Readout Based on Thin-Film Lithium Niobate Mach–Zehnder Modulators

Cryogenic optical data link for superconducting circuits

Photonic link from single-flux-quantum circuits to room temperature

A low-power integrated magneto-optic modulator on silicon for cryogenic applications

Photonic link from single flux quantum circuits to room temperature

Non-volatile Tuning of Cryogenic Optical Resonators

All optical operation of a superconducting photonic interface

An integrated optical modulator operating at cryogenic temperatures

Readout of Superconducting Nanowire Single Photon Detectors through Forward Biased Optical Modulators

Cryogenic operation of silicon photonic modulators based on DC Kerr effect

Cryogenic electro-optic modulation in titanium in-diffused lithium niobate waveguides

All-optical single-shot readout of a superconducting qubit

Cryogenic Optical-to-Microwave Conversion Using Si Photonic Integrated Circuit Ge Photodiodes

Optical Bias and Cryogenic Laser Readout of a Multipixel Superconducting Nanowire Single Photon Detector

An ultrahigh-impedance superconducting thermal switch for interfacing superconductors to semiconductors and optoelectronics

Photonic Readout of Superconducting Nanowire Single Photon Counting Detectors

Multiplexed quantum transport using commercial off-the-shelf CMOS at sub-kelvin temperatures

R&D Towards Cryogenic Optical Links

Cryogenic photonic link using an extended-InGaAs photodiode and short pulse illumination towards high-fidelity drive of superconducting qubits