Abstract:A fundamental challenge of the quantum revolution is to efficiently interface the quantum computing systems operating at cryogenic temperatures with room temperature electronics and media for high data-rate communication. Current approaches to control and readout of such cryogenic computing systems use electrical cables, which prevent scalability due to their large size, heat conduction, and limited bandwidth1. A more viable approach is to use optical fibers which allow high-capacity transmission and thermal isolation. A key component in implementing photonic datalinks is a cryogenic optical modulator for converting data from the electrical to the optical domain at high speed and with low power consumption, while operating at temperatures of 4 K or lower. Cryogenic modulators based on the electro-optic effect have been demonstrated in a variety of material platforms, however they are voltage driven components while superconducting circuits are current based, resulting in a large impedance mismatch. Here, we present the first demonstration of an integrated current-driven modulator based on the magneto-optic effect operating over a wide temperature range that extends down to less than 4 K. The modulator works at data rates up to 2 Gbps with energy consumption below 4 pJ/bit, and we show that this figure can be reduced to less than 40 fJ/bit with optimized design and fabrication. This modulator is a hybrid device, where a current-driven magneto-optically active crystal (cerium substituted yttrium iron garnet, or Ce:YIG) is bonded to a high-quality silicon microring resonator. Because of its potential for extremely low power consumption under cryogenic conditions, the class of magneto-optical modulators demonstrated here has the potential to enable efficient data links in large-scale systems for quantum information processing.

Cryogenic Photonic Readout Based on Thin-Film Lithium Niobate Mach–Zehnder Modulators

Cryogenic electro-optic interconnect for superconducting devices

A low-power integrated magneto-optic modulator on silicon for cryogenic applications

Photonic link from single-flux-quantum circuits to room temperature

An integrated optical modulator operating at cryogenic temperatures

Non-volatile Tuning of Cryogenic Optical Resonators

Photonic link from single flux quantum circuits to room temperature

Cryogenic operation of silicon photonic modulators based on DC Kerr effect

Multiplexed quantum transport using commercial off-the-shelf CMOS at sub-kelvin temperatures

Cryogenic electro-optic modulation in titanium in-diffused lithium niobate waveguides

Cryogenic optical data link for superconducting circuits

R&D Towards Cryogenic Optical Links

Photonic Readout of Superconducting Nanowire Single Photon Counting Detectors

Cryogenic Feedforward of a Photonic Quantum State

High-performance integrated graphene electro-optic modulator at cryogenic temperature

Fast Thermo-Optical Modulators with Doped-Silicon Heaters Operating at 2 Μm.

Cryogenic fiber-coupled electro-optic characterization platform for high-speed photodiodes

Optical Bias and Cryogenic Laser Readout of a Multipixel Superconducting Nanowire Single Photon Detector

Cryogenic Electro-Optic Polarisation Conversion in Titanium in-diffused Lithium Niobate Waveguides

All-optical single-shot readout of a superconducting qubit