Abstract:In this research, an experimental investigation of hybrid nanofluid mixed convection heat transfer characteristics is conducted. The research specifically investigates the effects of percentage weight composition (PWC) of nanoparticles in the hybrid nanofluids on mixed convection heat transfer characteristics along the lamina, transition and turbulent regions. Transition boundaries, thermal entrance effects, and the influence of tube axial position were also critically investigated and analysed experimentally. Three hybrid nanofluids of Al 2 O 3 – MWCNT (i.e., Al 2 O 3 (60%) – MWCNT (40%), Al 2 O 3 (50%) – MWCNT (50%) and Al 2 O 3 (40%) – MWCNT (60%)) were prepared using two-step method and then subjected to a constant heat flux through a horizontal circular copper tube with an internal diameter of 8mm. Results show a significant change in heat transfer characteristics with different PWCs. Al 2 O 3 (60%) – MWCNT (40%) have shown a better heat transfer enhancement among the three fluids investigated. Its Nusselt number has an enhancement of more than 5 % better than the other two fluids. Along the transition regime, critical Reynold numbers (Re cr ) of the three nanofluids were found to have differed slightly, with Re cr = 2020, 2000 and 2100 for Al 2 O 3 (60%) – MWCNT (40%), Al 2 O 3 (50%) – MWCNT (50%) and Al 2 O 3 (40%) – MWCNT (60%) respectively. Mixed convection effects were found to be more significant with Al 2 O 3 (60%) – MWCNT (40%) than with the other two fluids. At the axial position of 63.75, its mixed convection strength (Ὠ) was about 41%, which is the highest among the three fluids. Its strength of mixed convection was also found to deteriorate to about 14.75% with an increase in axial distance from the tube inlet. A similar observation was also noticed with other fluids. Thermal entrance effects were only found to be significant at x/d = 15 and 31.25, as their influence diminishes with an increased x/d distance from the tube inlet. It was concluded that both mixed convection and thermal entrance effects resulted in heat transfer enhancement, especially in the lamina region. Their influences decrease with an increase in axial distance from the tube inlet. Mixed convection influences were only present in the lamina and transition region, and their strength was reduced with an increase in Reynold number and axial position.

Experimental measurement of viscosity and electrical conductivity of water-based γ-Al2O3/MWCNT hybrid nanofluids with various particle mass ratios

Experimental Investigation on Stability, Viscosity, and Electrical Conductivity of Water-Based Hybrid Nanofluid of MWCNT-Fe2O3

Thermophysical properties of Al2O3-CuO hybrid nanofluid at different nanoparticle mixture ratio: An experimental approach

Stability and thermal conductivities of hybrid sphere/tube TiO2 nanofluid

Experimental investigation of rheological behavior of the hybrid nanofluid of MWCNT–alumina/water (80%)–ethylene-glycol (20%)

Studies on Evaluation of the Thermal Conductivity of Alumina Titania Hybrid Suspension Nanofluids for Enhanced Heat Transfer Applications

Experimental measurement of thermal conductivity and viscosity of Al 2 O 3 -GO (80:20) hybrid and mono nanofluids: A new correlation

An experimental investigation into the effect of particle mixture ratio on specific heat capacity and dynamic viscosity of Al2O3-ZnO hybrid nanofluids

An efficient enhancement in thermal conductivity of water-based hybrid nanofluid containing MWCNTs-COOH and Ag nanoparticles: experimental study

Thermal Conductivity of Al2O3 and CeO2 Nanoparticles and Their Hybrid Based Water Nanofluids: An Experimental Study

Optimizing mixing ratio of multi-walled carbon nanotubes and titanium dioxide: A green approach to high-performance hybrid nanofluids for heat transfer

Effect of volume concentration and nanofluid temperature on the thermal conductivity of mono and hybrid Al2O3-TiO2 nanofluid

Study on Enhanced Heat Transfer and Stability Characteristics of Al2O3–SiO2/Water Hybrid Nanofluids

Mixed Convection Heat Transfer Characteristics of Al 2 O 3 – MWCNT Hybrid Nanofluid under Thermally Developing Flow; Effects of Particles Percentage Weight Composition

Particle size-dependent rheological behavior and mechanism of Al2O3-Cu/W hybrid nanofluids

Experimental investigations of effects of nanoparticle size on force convective heat transfer characteristics of Al 2 O 3 - MWCNT hybrid nanofluids in transitional flow regime

Experimental study on the thermal properties of Al2O3‐CuO/water hybrid nanofluids: Development of an artificial intelligence model

A new model for viscosity prediction for silica-alumina-MWCNT/Water hybrid nanofluid using nonlinear curve fitting

Synthesis of new dihybrid nanofluid of TiO2/MWCNT in water–ethylene glycol to improve mixture thermal performance: preparation, characterization, and a novel correlation via ANN based on orthogonal distance regression algorithm

Experimental investigation of dynamic viscosity of water-based nanofluids containing tungsten oxide–multi-walled carbon nanotubes–zirconium oxide nanoparticles at mono and hybrid conditions

Experimental investigations of stability, density, thermal conductivity, and electrical conductivity of solar glycol-amine-functionalized graphene and MWCNT-based hybrid nanofluids