Abstract:The nanofluids characterization is of fundamental importance to predict their applicability in a real heat transfer situation. In addition to the transport properties, the nanofluid stability is an important factor to be studied, due to the long pumping, heating, cooling and resting cycles the fluids are usually subjected to. Carbon nanotubes have great potential to be used in nanofluids, due to their high thermal conductivity and low density. However, for aqueous medium, stability requires the use of stabilization methods. This work carried out the study of the transport properties and stability of nanofluids with multiwalled carbon nanotubes (MWCNT), using three stabilization methods: Triton X-100 (TrX–MWCNT) and Arabic gum (AG–MWCNT) as surfactants and functionalized carbon nanotubes with COOH group (COOH–MWCNT). These three nanofluids were compared to investigate the best configuration for heat transfer processes. The thermal conductivity was studied using the hot wire method; rheology was studied through three curves in rotational rheometer of concentric cylinders; specific heat was studied by the differential scanning calorimetry method; density was measured by the Coriolis Effect method; nanoparticles size and zeta potential were measured by the dynamic light scattering method. The COOH–MWCNT nanofluids present the highest thermal conductivity increase reaching 15% at 60 °C and 12% at 30 °C with 1wt% while the A.G–MWCNT and TrX–MWCNT reach 11% and 7.5%, respectively, at 30 °C. A.G–MWCNT nanofluids showed greater stability after long sonication times, while COOH–MWCNT presents best dispersion at 0.125 and 0.25 wt%, from 40 to 160 min of sonication. The specific heat increases with temperature and decreases with MWCNT concentration; however, it presents a peculiar increase in the concentration of 0.25 wt%, increasing about 0.5% and 4.5% for A.G–MWCNT and COOH–MWCNT, respectively at 60 °C. COOH–MWCNT nanofluids showed a thixotropic behavior for 0.5 and 1.0 wt% and large viscosity increase reaching 3.75 and 5.5 times the base fluid viscosity at 5 °C and 60 °C, respectively, with 1 wt%. The nanofluids A.G–MWCNT and COOH–MWCNT present good stability, as well as an increase in transport properties, optimized at a concentration close to 0.25 wt% and the COOH–MWCNT nanofluids can be stabilized simply by changing the water pH.

Experimental investigations of stability, density, thermal conductivity, and electrical conductivity of solar glycol-amine-functionalized graphene and MWCNT-based hybrid nanofluids

Experimental Investigation on Stability, Viscosity, and Electrical Conductivity of Water-Based Hybrid Nanofluid of MWCNT-Fe2O3

Progress and prospects on stability and thermal properties of surfactant assisted graphene, carbon nanotubes based nanofluid and their hybrid for next-generation thermal management

Investigation of thermal conductivity, viscosity, and electrical conductivity of graphene based nanofluids

Experimental measurement of viscosity and electrical conductivity of water-based γ-Al2O3/MWCNT hybrid nanofluids with various particle mass ratios

Thermal Conductivity and Rheological Studies for Graphene-Al2O3 / Ethylene Glycol-Water Hybrid Nanofluid at Low Temperatures

Thermal conductivity enhancement of ethylene glycol and water with graphene nanoplatelets

Surfactant-free ionic liquid-based nanofluids with remarkable thermal conductivity enhancement at very low loading of graphene

Study on preparation, stability, thermal conductivity, and viscosity of silver nanoparticles-decorated three-dimensional graphene-like porous carbon hybrid nanofluids

MWCNT and COOH–MWCNT aqueous nanofluids: thermophysical and rheological characterization

Graphene nanoplatelet nanofluids stabilised by hybridisation with graphene oxide: preparation, stability, and performance in flat plate solar thermal collector

Cu-Graphene water-based hybrid nanofluids: synthesis, stability, thermophysical characterization, and figure of merit analysis

Significant thermal conductivity enhancement for nanofluids containing graphene nanosheets

Experimental investigation of rheological behavior of the hybrid nanofluid of MWCNT–alumina/water (80%)–ethylene-glycol (20%)

Synthesis and characterization of graphene oxide-based nanofluids and study of their thermal conductivity

Studies on Evaluation of the Thermal Conductivity of Alumina Titania Hybrid Suspension Nanofluids for Enhanced Heat Transfer Applications

Carbon nanotube–graphene-based nanofluids: a comprehensive review on the role of thermal conductivity and its solar energy applications

Stability and thermo-physical characteristics of EG/H2O-based nanofluid with graphene nanoplatelets for secondary coolant applications

Effects of Particle Surface Charge, Species, Concentration, and Dispersion Method on the Thermal Conductivity of Nanofluids

Investigation of thermal conductivity enhancement of water-based graphene and graphene/MXene nanofluids

Investigation on hybrid nanofluids based on carbon nanotubes filled with metal nanoparticles: Stability, thermal conductivity, and viscosity