Abstract:In this study, enhancements of thermal conductivities of ethylene glycol, water, and synthetic engine oil in the presence of copper (Cu), copper oxide (CuO), and multi-walled carbon nanotube (MWNT) are investigated using both physical mixing method (two-step method) and chemical reduction method (one-step method). The chemical reduction method is, however, used only for nanofluid containing Cu nanoparticle in water. The thermal conductivities of the nanofluids are measured by a modified transient hot wire method. Experimental results show that nanofluids with low concentration of Cu, CuO, or carbon nanotube (CNT) have considerably higher thermal conductivity than identical base liquids. For CuO-ethylene glycol suspensions at 5 vol.%, MWNT-ethylene glycol at 1 vol.%, MWNT-water at 1.5 vol.%, and MWNT-synthetic engine oil at 2 vol.%, thermal conductivity is enhanced by 22.4, 12.4, 17, and 30%, respectively. For Cu-water at 0.1 vol.%, thermal conductivity is increased by 23.8%. The thermal conductivity improvement for CuO and CNT nanofluids is approximately linear with the volume fraction. On the other hand, a strong dependence of thermal conductivity on the measured time is observed for Cu-water nanofluid. The system performance of a 10-RT water chiller (air conditioner) subject to MWNT/water nanofluid is experimentally investigated. The system is tested at the standard water chiller rating condition in the range of the flow rate from 60 to 140 L/min. In spite of the static measurement of thermal conductivity of nanofluid shows only 1.3% increase at room temperature relative to the base fluid at volume fraction of 0.001 (0.1 vol.%), it is observed that a 4.2% increase of cooling capacity and a small decrease of power consumption about 0.8% occur for the nanofluid system at a flow rate of 100 L/min. This result clearly indicates that the enhancement of cooling capacity is not just related to thermal conductivity alone. Dynamic effect, such as nanoparticle dispersion may effectively augment the system performance. It is also found that the dynamic dispersion is comparatively effective at lower flow rate regime, e.g., transition or laminar flow and becomes less effective at higher flow rate regime. Test results show that the coefficient of performance of the water chiller is increased by 5.15% relative to that without nanofluid.

Investigation of thermal conductivity enhancement of water-based graphene and graphene/MXene nanofluids

Experimental study on the thermal conductivity enhancement of water based nanofluids using different types of carbon nanotubes

Thermo-physical properties of water-based single-walled carbon nanotube nanofluid as advanced coolant

Heat Transfer During Constrained Melting Of Graphite-Based Nanofluids In A Spherical Capsule

Experimental study on preparation and heat transfer efficiency of ethylene glycol/water-based hybrid nanofluids enhanced by graphene oxide/MXene nanoparticles

Significant thermal conductivity enhancement for nanofluids containing graphene nanosheets

Experimental Investigation of Graphene Nanofluid and Numerical Simulation of Its Natural Convection in a Square Enclosure

A critical review on thermal conductivity enhancement of graphene-based nanofluids

Recent Advances in Thermal Conductivity and Thermal Applications of Graphene and Its Derivatives Nanofluids

Thermal conductivity enhancement of water by adding graphene Nano-sheets: Consideration of particle loading and temperature effects

Surfactant-free ionic liquid-based nanofluids with remarkable thermal conductivity enhancement at very low loading of graphene

Thermodynamic Properties and Thermal Stability of Ionic Liquid-Based Nanofluids Containing Graphene As Advanced Heat Transfer Fluids for Medium-to-high-temperature Applications

Analysis of the mechanism of enhanced heat transfer by nanofluids

Ti3C2Tx MXene contained nanofluids with high thermal conductivity, super colloidal stability and low viscosity

Investigation on the stability, thermal conductivity and viscosity of MXene/water nanofluids and development of ANN models

Thermophysical Profile of Industrial Graphene Water-Based Nanofluids

Fluid flow and heat transfer of carbon nanotubes- or graphene nano platelets-based nanofluids in a channel with micro-cylinders: an experimental study

Experimental study on the effect of different surfactants on the thermophysical properties of graphene filled nanofluids

Investigation of the Thermal Conductivity, Viscosity, and Thermal Performance of Graphene Nanoplatelet-Alumina Hybrid Nanofluid in a Differentially Heated Cavity

Enhancements of thermal conductivities with Cu, CuO, and carbon nanotube nanofluids and application of MWNT/water nanofluid on a water chiller system

Investigation on hybrid nanofluids based on carbon nanotubes filled with metal nanoparticles: Stability, thermal conductivity, and viscosity