Particle size-dependent rheological behavior and mechanism of Al2O3-Cu/W hybrid nanofluids
Ming-yan Ma,Yu-ling Zhai,Zhou-hang Li,Pei-tao Yao,Hua Wang
DOI: https://doi.org/10.1016/j.molliq.2021.116297
IF: 6
2021-08-01
Journal of Molecular Liquids
Abstract:In order to investigate complicated interactions between nanoparticles of different sizes on the rheological characteristics of hybrid nanofluids, Al2O3-Cu/W hybrid nanofluids with volume fractions of 0.3–1.5 vol% were studied in the present study. Moreover, 50 nm Cu nanoparticles and different sizes of Al2O3 nanoparticles, including 20, 30 and 50 nm particles, were utilized in the experiments. Obtained experimental results showed that as the volume fraction increases, the viscosity increases too. When the volume fraction reaches 0.3 vol%, the viscosity increases as the nanoparticle size increases. Moreover, it was found that 20 nm-Al2O3-Cu/W has the lowest viscosity at room temperature. When the volume fraction is higher than 0.3 vol%, the viscosities of 30 nm-Al2O3-Cu/W and 50 nm-Al2O3-Cu/W are low. Moreover, 20 nm-Al2O3-Cu/W hybrid nanofluid shows Newtonian behavior only at low concentrations (<0.3 vol%) and low shear rates (<100 s−1). However, 30 nm-Al2O3-Cu/W and 50 nm-Al2O3-Cu/W are all non-Newtonian fluids. Analysis of variance (ANOVA) indicates that the volume fraction significantly affects the viscosity, contributing to more than 45% in studied temperatures, while the influence of the nanoparticle size is 25%. Finally, it is found that the synergistic effect in hybrid nanofluids affects the nanoparticle arrangement. Accordingly, low-viscosity nanofluids can be achieved by adding nanoparticles of small size at low volume fractions, while large-size nanoparticles are achieved in high volume fractions. The present article is expected to broaden the understanding of the nanoparticle size on the viscosity of hybrid nanofluids.
chemistry, physical,physics, atomic, molecular & chemical