Abstract:In this research, an experimental investigation of hybrid nanofluid mixed convection heat transfer characteristics is conducted. The research specifically investigates the effects of percentage weight composition (PWC) of nanoparticles in the hybrid nanofluids on mixed convection heat transfer characteristics along the lamina, transition and turbulent regions. Transition boundaries, thermal entrance effects, and the influence of tube axial position were also critically investigated and analysed experimentally. Three hybrid nanofluids of Al 2 O 3 – MWCNT (i.e., Al 2 O 3 (60%) – MWCNT (40%), Al 2 O 3 (50%) – MWCNT (50%) and Al 2 O 3 (40%) – MWCNT (60%)) were prepared using two-step method and then subjected to a constant heat flux through a horizontal circular copper tube with an internal diameter of 8mm. Results show a significant change in heat transfer characteristics with different PWCs. Al 2 O 3 (60%) – MWCNT (40%) have shown a better heat transfer enhancement among the three fluids investigated. Its Nusselt number has an enhancement of more than 5 % better than the other two fluids. Along the transition regime, critical Reynold numbers (Re cr ) of the three nanofluids were found to have differed slightly, with Re cr = 2020, 2000 and 2100 for Al 2 O 3 (60%) – MWCNT (40%), Al 2 O 3 (50%) – MWCNT (50%) and Al 2 O 3 (40%) – MWCNT (60%) respectively. Mixed convection effects were found to be more significant with Al 2 O 3 (60%) – MWCNT (40%) than with the other two fluids. At the axial position of 63.75, its mixed convection strength (Ὠ) was about 41%, which is the highest among the three fluids. Its strength of mixed convection was also found to deteriorate to about 14.75% with an increase in axial distance from the tube inlet. A similar observation was also noticed with other fluids. Thermal entrance effects were only found to be significant at x/d = 15 and 31.25, as their influence diminishes with an increased x/d distance from the tube inlet. It was concluded that both mixed convection and thermal entrance effects resulted in heat transfer enhancement, especially in the lamina region. Their influences decrease with an increase in axial distance from the tube inlet. Mixed convection influences were only present in the lamina and transition region, and their strength was reduced with an increase in Reynold number and axial position.

Study on Enhanced Heat Transfer and Stability Characteristics of Al2O3–SiO2/Water Hybrid Nanofluids

Stability and thermal conductivities of hybrid sphere/tube TiO2 nanofluid

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Turbulent heat transfer and flow analysis of hybrid Al2O3-CuO/water nanofluid: An experiment and CFD simulation study

Studies on Evaluation of the Thermal Conductivity of Alumina Titania Hybrid Suspension Nanofluids for Enhanced Heat Transfer Applications

Analysis of the mechanism of enhanced heat transfer by nanofluids

Experimental Investigation on Stability, Viscosity, and Electrical Conductivity of Water-Based Hybrid Nanofluid of MWCNT-Fe2O3

Heat transfer and flow characteristics of hybrid Al2O3/TiO2–water nanofluid in a minichannel heat sink

Experimental investigation of a novel heat exchanger for optimizing heat transfer performance using Al2O3-water nanofluids

Efficient convective heat transfer enhancement in heat exchanger tubes with water based novel hybrid nanofluids: experimental investigation

Thermophysical properties of Al2O3-CuO hybrid nanofluid at different nanoparticle mixture ratio: An experimental approach

Investigation of Thermodynamic Properties and Stability of Metal Oxide (CuO and Al2O3)/Deionized Water Nanofluids for Enhanced Heat Transfer Applications

Experimental study on the thermal properties of Al2O3‐CuO/water hybrid nanofluids: Development of an artificial intelligence model

Experimental measurement of viscosity and electrical conductivity of water-based γ-Al2O3/MWCNT hybrid nanofluids with various particle mass ratios

Enhancing Heat Transfer Performance: Nanofluids Application in Helical Microfin Tube Concentric Heat Exchangers

Thermal Conductivity of Al2O3 and CeO2 Nanoparticles and Their Hybrid Based Water Nanofluids: An Experimental Study

An experimental study on characterization, stability and dynamic viscosity of CuO-TiO2/water hybrid nanofluid

Analysis of the heat transfer enhancement in water-based micropolar hybrid nanofluid flow over a vertical flat surface

Heat transfer characteristics of plate heat exchanger using hybrid nanofluids: effect of nanoparticle mixture ratio

Mixed Convection Heat Transfer Characteristics of Al 2 O 3 – MWCNT Hybrid Nanofluid under Thermally Developing Flow; Effects of Particles Percentage Weight Composition

Effect of Al2O3/water nanofluid on performance of parallel flow heat exchangers