Abstract:Recent electronic industry developments require a variety of compact and high-performance heat sinks for the heat dissipation of electronic devices. In this paper, on the basis of a new type of heat pipe called the metal foam multichannel heat pipe (metal foam MCHP) proposed by our team, an experimental apparatus on its heat transfer characteristics was built. The heat transfer characteristics of the metal foam MCHP with the distilled water as the working fluid were experimentally investigated in a heat flux range of (18750-112500) W/m(2), a filling ratio range of 0.1-0.6 and single-sided/double-sided heating modes. The experimental results showed that the working fluid could flow up and down in the metal foam MCHP, and thus the heat was transferred from the evaporation section to the condensation section during the operation. The thermal resistance of the metal foam MCHP decreased with the increase of the heat flux. When the heat flux was up to 112500 W/m(2), the thermal resistance decreased to 0.142 degrees C/W. The optimal filling ratio of the metal foam MCHP charging with the distilled water was 0.2. During the experiment, the temperature fluctuations of each measuring point in the evaporation section were almost within 2 degrees C and the temperature differences of different measuring points in the evaporation section were within 8 degrees C. The thermal resistances of the metal foam MCHP under the single-side heating mode and the double-sided heating mode were compared, and the thermal resistance of the metal foam MCHP was found to be higher under the single-sided heating mode. In addition, compared with the traditional PHPs, the metal foam MCHP showed better heat transfer performance and better stability and uniformity of the evaporation temperature. (C) 2020 Elsevier Ltd. All rights reserved.

Experimental study on heat transfer characteristics of flow on an inclined hot metal plate

Experimental Investigation of Spray Cooling Performance in Non‐boiling Zone on Rough Superhydrophilic/hydrophobic Surfaces

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Air-side Performance of Open-Cell Metal Foams for Use in Dehumidifying Heat Exchangers

Experimental investigation on confined jet impingement boiling heat transfer characteristics on metal foam cover

Experimental study on thermal and flow characteristics of metal foam heat pipe radiator

Experimental investigation of metal foam embedded surface thermal characteristics using air-jet impingement with different orifice geometry

Wall Heat Transfer Characteristic of Parallel-plate Channel Filled with Open-cell Metal Foams in Large Flow Velocity Range

Experimental investigation of the subcooled flow boiling heat transfer of water and nanofluids in a horizontal metal foam tube

Numerical Investigation of Fluid Flow and Heat Transfer in High-Temperature Wavy Microchannels with Different Shaped Fins Cooled by Liquid Metal

Pore-scale Simulation of Forced Convection Heat Transfer under Turbulent Conditions in Open-Cell Metal Foam

Pore-scale Simulation of Forced Convection Heat Transfer in Metal Foams with Uniform and Gradient Structures

Heat transfer characteristics of the flat plate integrated with metal foam of varying thickness using an unconfined circular air-jet impingement

Flow behavior and heat transfer characteristics of liquid film on vertical hot surface by inclined jet impingement

Effect of End Shape on Flow and Heat Transfer Characteristics of Two Parallel Plates

Experimental Investigation on the Effects of Inclination Angle on Heat Transfer Performance of a Liquid Metal High-Temperature Oscillating Heat Pipe

Experimental and numerical study of the effect of conjugate heat transfer on film cooling

Experimental and numerical study of structural parameters on the heat transfer performance of submerged cooling system

Pore-scale numerical investigation on comprehensive heat transfer performance of homogeneous and graded metal foam heat sinks based on tetrakaidecahedron cell

Enhanced heat transfer performance of optimized micro-channel heat sink via forced convection in cooling metal foam attached on copper plate

Numerical study of a hybrid thermal lattice Boltzmann method for pool boiling heat transfer on a modeled hydrophilic metal foam surface