Abstract:High performance thermal energy systems are crucial in fulfilling the growing demand of thermal energy. Consequently, numerous heat transfer enhancements have been proposed. Some of the promising methods are boiling flow heat transfer, helical coiled tube and metal foam insert. Although the performance of each strategy has been extensively studied, based on our literature review, the effectiveness of combining these strategies has not been investigated. This missing information may impede further development of efficient heat transfer systems. This study is therefore performed to investigate subcooled flow boiling heat transfer in helical tube with copper foam insert. A high-resolution three-dimensional pore scale model that considers the shape, porosity and pore density of the metal foam is developed and validated against the published experimental results. Using the model, the effect of inlet temperature, mass flux, wall heat flux, porosity, pore density and half-filled metal foam are studied. The results suggest that operating parameters have mild effects on the heat transfer performance. In contrast, porosity and pore density show significant influence in heat transfer coefficient and pressure drop. It has also been found that total heat transfer surface area and base area are better in characterizing heat transfer in pore-scale level than porosity and pore density at pore-scale level. Moreover, implementing metal foam at outer half of the tube is observed to offer slightly better heat transfer than implementing it at the inner side by around 4.8%. Overall, this study indicates that helical metal foam tubes offer the best performance at mass flux of 200 kg/m 2 ∙s with performance index of 0.72, while straight tubes with 0.90 porosity has the highest performance index of 0.66. Empirical correlations to relate dimensionless parameters to the Nusselt number and friction factor is generated. Finally, the model developed in this study can serve to provide guidelines for the upcoming studies in boiling in metal foam structure and assist in designing metal foam heat exchangers.

Experimental investigation on confined jet impingement boiling heat transfer characteristics on metal foam cover

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Experimental investigation of metal foam embedded surface thermal characteristics using air-jet impingement with different orifice geometry

Experimental study on heat transfer characteristics of flow on an inclined hot metal plate

Experimental investigation of the subcooled flow boiling heat transfer of water and nanofluids in a horizontal metal foam tube

Heat transfer analysis of subcooled flow boiling in copper foam helical coiled heat exchanger – A pore-scale numerical study

Pore-scale Simulation of Forced Convection Heat Transfer under Turbulent Conditions in Open-Cell Metal Foam

Numerical analysis of the heat transfer enhancement by using metal foam

Effect of Metal Foam Insert Configurations on Flow Boiling Heat Transfer and Pressure Drop in a Rectangular Channel

Heat transfer characteristics of the flat plate integrated with metal foam of varying thickness using an unconfined circular air-jet impingement

Pore-scale Simulation of Forced Convection Heat Transfer in Metal Foams with Uniform and Gradient Structures

Influence of thickness of metal foam on the conduction and convection heat transfer for a flat plate with metal foam impinged by a single circular air jet

Experimental investigation on the influence of copper foam characteristics on pool boiling heat transfer

Unlocking the Thermal Efficiency of Irregular Open-Cell Metal Foams: A Computational Exploration of Flow Dynamics and Heat Transfer Phenomena

Effect of Metal Foam on Natural Convective Heat Transfer of Nanofluids in a Photothermal Conversion System

Augmentation of pool boiling heat transfer on tube bundles using metal foam

Numerical study of a hybrid thermal lattice Boltzmann method for pool boiling heat transfer on a modeled hydrophilic metal foam surface

Experimental study on thermal and flow characteristics of metal foam heat pipe radiator

Experimental Study on Boiling of Nanofluids in Copper Foam

Experimental investigation of permeability and Darcy-Forchheimer flow transition in metal foam with high pore density

Experimental Study of Boiling Heat Transfer Characteristics of Metal Foam Porous-wall Mini-channels