P-doping with beryllium of long-wavelength InAsSb

Stefan P Svensson,Wendy L Sarney,William A Beck,Jinghe Liu,Dmitri Donetsky,Sergey Suchalkin,Gregory Belenky,Alexandros Kyrtsos,Enrico Bellotti
DOI: https://doi.org/10.1088/1361-6641/abb7c0
IF: 2.048
2020-10-13
Semiconductor Science and Technology
Abstract:Abstract The properties of low concentrations of Be as a p-dopant in InAsSb with a composition corresponding to absorption in the long wavelength infrared band were studied. Temperature- and magnetic field-dependent Hall effect data were analyzed with a multi-carrier model allowing extraction of the bulk hole concentration and mobility. The hole density exhibits a weak freeze-out with an activation energy of 3.2 meV. Density functional theory calculations indicate that Be favor the In sites as Be In with an acceptor binding energy near the valence band maximum. The hole mobility increases monotonically as the temperature is lowered, showing an alloy scattering-limited value of about 1000 cm 2 V −1 s −1 at 77 K and plateauing at around 3200 cm 2 V −1 s −1 at 20 K. Temperature-dependent photoluminescence was measured up to 200 K and did not indicate any deleterious effects induced by the acceptors. A superlinear bandgap vs temperature behavior is tentatively interpreted as a band-filling effect, which is reduced with added concentrations of acceptors.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter
What problem does this paper attempt to address?