Abstract:Double-wire gas metal arc welding (GMAW) is extensively studied for aluminum (Al) alloy welding due to its high productivity; however, problems such as excessive heat input and porosity remain. In this paper, the low-frequency synchronous (LFS) and low-frequency alternating (LFA) phases based on the double pulse were proposed to improve the heat input of Al alloy double-wire GMAW. Voltage and current waveforms of LFS and LFA phases are acquired, enabling the investigation of heat input characteristics and weld bead formation of LFS and LFA phases. Lastly, the influence of low-frequency phases on weld porosity is assessed. The experimental results have shown that the regular voltage, current waveforms, and continuous weld beads are obtained during LFS and LFA phases. In the LFS phase, the leading and trailing currents simultaneously occur in a strong or weak pulse phase. Further, the heat input fluctuates significantly, causing severe spatter, while fluctuations occur in the weld penetration. Furthermore, weld bead formation quality was poor. Compared with the LFS phase, the leading and trailing currents alternated in a strong or weak pulse phase in the LFA phase. The total LFA phase heat input was smoother, the weld spatter was limited, and the weld width was more uniform. The fish-scale ripples of the LFA phase were more obvious, while the bead formation quality was improved. Additionally, in the LFA phase, the weld pool maintained a fast flow rate and low solidification rate. The geometric parameters of the weld bead were more conducive to the escape of pores. Finally, the LFA phase porosity was notably lower compared with the LFS phase.

Dynamic Metal Transfer Behavior in Double-Wire DP-GMAW of Aluminum Alloy Under Different Pulse Phases

Effect of high-frequency phase shift on metal transfer and weld formation in aluminum alloy double-wire DP-GMAW

Arc Profile Characteristics of Al Alloy in Double-Pulsed GMAW

Investigation on the Dynamic Behavior of Weld Pool and Weld Microstructure During DP-GMAW for Austenitic Stainless Steel

Comparative Study of Droplet Transfer Modes on Appearance, Microstructure, and Mechanical Properties of Weld During Pulsed GMAW

Study on Welding Process and Prosperities of AA5754 Al-alloy Welded by Double Pulsed Gas Metal Arc Welding

Heat input characteristics and weld bead formation in double-wire double-pulsed GMAW of aluminum alloy under different low-frequency phases

Study on the Effect of Pulse Waveform Parameters on Droplet Transition, Dynamic Behavior of Weld Pool, and Weld Microstructure in P-GMAW

Effect of phase shift on arc interference and weld bead formation in aluminum alloy tandem GMAW with a median pulsed waveform

Metal transfer characteristics of GMAW with strip electrode

Investigation of the Difference in the Pulse Current in the Double Pulsed Gas Metal Arc Welding of Aluminum Alloys

Double-Pulse Triple-Wire MIG Welding of 6082-T6 Aluminum Alloy: Process Characteristics and Joint Performances

Metal transfer electrical characteristics and its analysis in pulsed current gas metal arc welding

Arc characteristic in aluminum alloy double-wire variable polarity double base pulsed gas metal arc welding

Effect of Forces on Dynamic Metal Transfer Behavior of Cable-Type Welding Wire Gas Metal Arc Welding

Arc Behavior and Droplet Transfer Analysis in AC-P-MIG Welding of Aluminum Alloys

Aluminum Alloys Pulsed MIG Welding Based on Dynamic Characteristics Self-Adaptation Control

Effects of Arc Length Adjustment on Weld Bead Formation and Droplet Transfer in Pulsed GMAW Based on Datum Current Time

Self-adjusting Dynamic Characteristics of Pulsed MIG Welding for Aluminum Alloys

Process Optimization, Microstructure and Mechanical Properties of Wire Arc Additive Manufacturing of Aluminum Alloy by Using DP-GMAW Based on Response Surface Method

Influences of Weaving Parameters on Dynamic Characteristics and Stability Control of the Droplet Transfer in Arc-Weaving P-GMAW Process