Abstract:This study presents an impedance-based structural health monitoring (SHM) technique considering temperature effects. The temperature variation results in significant impedance variations, particularly a frequency shift in the impedance, which may lead to erroneous diagnostic results of real structures, such as civil, mechanical, and aerospace structures. In order to minimize the effect of the temperature variation on the impedance measurements, a previously proposed temperature compensation technique based on the cross-correlation between the reference-impedance data and a concurrent impedance data is revisited. In this study, cross-correlation coefficient (CC) after an effective frequency shift (EFS), which is defined as the frequency shift causing two impedance data to have the maximum correlation, is utilized. To promote a practical use of the proposed SHM strategy, an automated continuous monitoring framework using MATLAB® is developed and incorporated with the current hardware system. Validation of the proposed technique is carried out on a lab-sized steel truss bridge member under a temperature varying environment. It has been found that the CC values have shown significant fluctuations due to the temperature variation, even after applying the EFS method. Therefore, an outlier analysis providing the optimal decision limits under the inevitable variations has been carried out for more systematic damage detection. It has been found that the threshold level shall be properly selected considering the daily temperature range and the minimum target damage level for detection. It has been demonstrated that the proposed strategy combining the EFS and the outlier analysis can be effectively used in the automated continuous SHM of critical structural members under temperature variations.

On-Wafer Temperature Monitoring Sensor for Condition Monitoring of Repaired Electrostatic Chuck

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

CMOS Digital Temperature Sensor with Self-Correcting Technique

Evaluation of surface temperature uniformity of multi-zone ceramic heaters with embedded cooling channels for electrostatic chuck

A Real-time In-situ Wafer Temperature Measurement System Based on Fiber Bragg Grating Array

Enhanced temperature uniformity of electrostatic chuck: ceramic surface contact ratio and backside gas pressure

Research on Wafer Temperature Monitoring in IC Process

An On-Line Temperature Monitoring Device

Automated Impedance-based Structural Health Monitoring Incorporating Effective Frequency Shift for Compensating Temperature Effects

Temperature Compensation of the MEMS-Based Electrochemical Seismic Sensors

A Novel On-board Temperature Monitoring Approach in the Reflow Soldering Process

Research on a Miniature Multiparameter Water Quality Sensor Chip and a System with a Temperature Compensation Function.

Measurement Techniques to Identify Soft Failure Sensitivity to ESD

A 840μm2 557nw All-Mos Temperature Sensor Front-End for SoC Thermal Monitoring

Development of Wafer-Type Plasma Monitoring Sensor with Automated Robot Arm Transfer Capability for Two-Dimensional In Situ Processing Plasma Diagnosis

An In Situ Approach to Real-Time Spatial Control of Steady-State Wafer Temperature During Thermal Processing in Microlithography

On-Chip Power Monitoring: Leveraging High-Sensitivity Differential Temperature Sensors With Chopper Stabilization and Offset Calibration

Ultrastable Eddy Current Displacement Sensor Working in Harsh Temperature Environments with Comprehensive Self-Temperature Compensation

Process kit and wafer temperature effects on dielectric etch rate and uniformity of electrostatic chuck

Development of On-line Monitoring System for the Insulation Condition of Capacitive-type Substation Equipment