Abstract:Silicon has been commonly used in the microelectromechanical systems (MEMS) community for the past sixty years, and anisotropic wet etching with tetramethylammonium hydroxide (TMAH) has been central to these fabrication efforts. It has been shown anisotropic wet etching of silicon is an ideal method to rapidly fabricate components with huge production volume, and low cost. Although TMAH has been commonly used to create integrated circuits, the technology hasn’t been fully explored for optical applications. Four types of light concentrating arrays were fabricated with this technology in this work: (i) micropyramids with 54.7˚ sidewall angle, (ii) microcones with 45˚ sidewall angle, (iii) inverted square pyramids with 54.7˚ sidewall angle, and (iv) inverted triangular pyramids with different sidewall angles. The 54.7˚ sidewall angle arrays have smooth sidewalls due to etching with TMAH, which reduces scattering loss. The 3-D microphotonic structures were created through a comparable fabrication protocol, but require different photoresists, mask alignments, and if the surfactant Triton X-100 was utilized during the etch. The fabricated structures can be either heterogeneously integrated with front-illuminated focal plane arrays (FPAs) created in material systems with high quantum efficiency, or be monolithically integrated with metal/silicide Schottky barrier photodetectors for operation in short-wave infrared (SWIR) or mid-wave infrared (MWIR) regimes. The light concentrating capability of the proposed structures was tested by finite-difference time-domain modeling. Experimentally, the formation of photonic nanojets at the tips of micropyramids was demonstrated using illumination by a 2.96 μm wavelength Er:YAG laser.

Microfabrication of 3D Free-Forms with Textured Surface Morphology in Monocrystalline Silicon using Grayscale Technology

Beyond 100 nm Resolution in 3D Laser Lithography: Post Processing Solutions

Mask-Free Construction of Three-Dimensional Silicon Structures by Dry Etching Assisted Gray-Scale Femtosecond Laser Direct Writing

Optimization of Grayscale Lithography for the Fabrication of Flat Diffractive Infrared Lenses on Silicon Wafers

A novel hardmask-to-substrate pattern transfer method for creating 3D, multi-level, hierarchical, high aspect-ratio structures for applications in microfluidics and cooling technologies

Reconfigurable phase-change photomask for grayscale photolithography

Scalable fabrication of hemispherical solid immersion lenses in silicon carbide through grayscale hard-mask lithography

Grayscale Electron Beam Lithography Direct Patterned Antimony Sulfide

Gray-tone Lithography for Micro Opto-Device of Arbitrary 3D Shaped Surfaces

Combining thermal scanning probe lithography and dry etching for grayscale nanopattern amplification

Controllable Si micro-structuring by temporally modulated single-shot femtosecond pulse lithography

Direct Imprinting of Porous Silicon Via Metal‐Assisted Chemical Etching

A New Fabrication Method for 3D Multilayer Microstructure

Grayscale Lithography and a Brief Introduction to Other Widely Used Lithographic Methods: A State-of-the-Art Review

Fabrication of highly homogeneous and controllable nanogratings on silicon via chemical etching-assisted femtosecond laser modification

DMD-based Gray-tone Lithography for Fabrication of Continuous Profile Microstructure

Complex microstructure fabrication by integrating silicon anisotropic etching and UV-LIGA technology

A simple method for producing freestanding 3D microstructures by integrated photomask micromolding

A route to engineered high aspect-ratio silicon nanostructures through regenerative secondary mask lithography

Fabrication of 3-D light concentrating microphotonic structures by anisotropic wet etching of silicon

Laser Lithography of Monolithically‐Integrated Multi‐Level Microchannels in Silicon