Zirconia Fiber Containing TRIP‐Matrix Composites Prepared via Paper‐Manufacturing Technology

Claudia Heuer,Nora Brachhold,Christos G. Aneziris

DOI: https://doi.org/10.1002/adem.202001154

IF: 3.6

2020-12-02

Advanced Engineering Materials

Abstract:In this study the continuous further development of metal matrix composites prepared by paper‐manufacturing technology is in focus. The composites are based on metastable austenitic stainless steel with addition of magnesia partially stabilized zirconia particles or yttria‐stabilized zirconia fibers. The sintering conditions have been profoundly investigated, in order to study and subsequently inhibit the formation of carbides, which deteriorated the mechanical performance of the paper‐derived materials in the past. The cellulose pulp fiber content as well as the filler particle content was adjusted with the aim to improve the mechanical performance of the paper‐derived materials during tensile load testing. Additionally, the cellulose pulp fibers were partially replaced by yttria‐stabilized zirconia fibers. The improved composites that contained 3 and 6 vol.% of yttria‐stabilized zirconia fibers exhibited ultimate tensile strengths of 264 MPa and 322 MPa. The tensile strain of the improved TRIP‐matrix composites as well as of the reference material has been significantly increased (up to 10 %) as compared with our previous study, where all materials showed brittle fracture behavior. This can certainly be attributed to the improvements in the sintering process and the corresponding prevention of carbide formation during heat treatment upon cooling.This article is protected by copyright. All rights reserved.

materials science, multidisciplinary