Abstract:Coprecipitation is the most commonly used method to synthesize iron oxide nanoparticles (IONPs) due to its low cost and environmentally friendly synthesis process. Recently, several studies have proposed that the coprecipitation formation of IONPs is through the aggregation of initially formed primary particles. However, there are still lack of systematic researches about the room temperature coprecipitation formation process of IONPs under quick mixing mode. Here, a gas/liquid mixed phase fluidic reactor was specially designed, and the influences of reaction time, reaction pH and valence of iron ions on the coprecipitation formation of IONPs in quick mixing mode were studied. The NH3 gas was used as the alkaline reactant. At pH above 10.0, the iron ions promptly hydrolyzed and precipitated to form primary nanoparticles, and then the primary nanoparticles accreted to form Fe3O4 nanoparticles in 2 min 30 s. As the reaction pH increased from 2.5 to 9.5, extremely small particles gradually aggregated to form Fe3O4 nanoparticles. Large Fe3O4 nanoparticles with a mean diameter of ~ 8.1 nm were completely formed at pH 9.5. And a small amount of poorly crystalline intermediate phases including akageneite, ferrihydrite and goethite were observed during this process. When Fe2+ ions were absent during the reaction process, the final products had poor crystallinity and weak magnetic properties. While if only Fe2+ ions were used in the precursor, the sheet-like green rusts generated firstly, and Fe3O4 nanoparticles would gradually form on the surface of green rusts with the partial oxidation of Fe2+ ions. The results of regulating the reaction conditions especially reaction pH indicate that this reaction design can effectively reduce the formation of intermediate crystal phases.

A useful preparation of ultrasmall iron oxide particles by using arc plasma deposition

Influence of Different Preparation Methods on Crystallisation and Morphology of Fe2o3 Nanoparticles

Preparation of Iron Nanoparticles from Iron Pentacarbonyl Using an Atmospheric Microwave Plasma

Iron oxide/graphene oxide nanocomposite synthesis using atmospheric cold plasma

Ultra-fast Self-Assembly and Stabilization of Reactive Nanoparticles in Reduced Graphene Oxide Films

Synthesis of Ultra-Fine Iron Powder by Combining the Flame Aerosol Synthesis and Postreduction

The coprecipitation formation study of iron oxide nanoparticles with the assist of a gas/liquid mixed phase fluidic reactor

Preparation of Nanoparticles with an Environment-Friendly Approach

A Facile Route for the Preparation of Monodisperse Iron nitride at Silica Core/shell Nanostructures

Study on the Synthesis and Application of Core-Shell Structured Nanoparticles of Fe3O4

Mixed phase iron oxides thin layers by atmospheric-pressure chemical vapor deposition method

Ultrasonic-assisted Preparation of Monodisperse Iron Oxide Nanoparticles

Synthesis of Uniform Ferric Oxide Particles from Deionized Colloids

Aerosol synthesis of phase-controlled iron-graphene nanohybrids through FeOOH nanorod intermediates.

Preparation Of Tin Oxide Ultrafine Particle Films

Present Status and Preparation Technologys of Iron Oxide Nanoparticles

Preparation of Gamma Iron Oxide Particulate by a Low Temperature Flux Method

New Sustainable, Scalable and One-Step Synthesis of Iron Oxide Nanoparticles by Ion Exchange Process

A Size-Controllable Preparation Method for Indium Tin Oxide Particles Using A Membrane Dispersion Micromixer

Plasma way to obtain ultrafine iron and aluminum oxides

Facile Preparation of Α-Fe2o3/carbon and Polyhydroxy Iron Cation/polyaniline Hollow Particles