Abstract:Coprecipitation is the most commonly used method to synthesize iron oxide nanoparticles (IONPs) due to its low cost and environmentally friendly synthesis process. Recently, several studies have proposed that the coprecipitation formation of IONPs is through the aggregation of initially formed primary particles. However, there are still lack of systematic researches about the room temperature coprecipitation formation process of IONPs under quick mixing mode. Here, a gas/liquid mixed phase fluidic reactor was specially designed, and the influences of reaction time, reaction pH and valence of iron ions on the coprecipitation formation of IONPs in quick mixing mode were studied. The NH3 gas was used as the alkaline reactant. At pH above 10.0, the iron ions promptly hydrolyzed and precipitated to form primary nanoparticles, and then the primary nanoparticles accreted to form Fe3O4 nanoparticles in 2 min 30 s. As the reaction pH increased from 2.5 to 9.5, extremely small particles gradually aggregated to form Fe3O4 nanoparticles. Large Fe3O4 nanoparticles with a mean diameter of ~ 8.1 nm were completely formed at pH 9.5. And a small amount of poorly crystalline intermediate phases including akageneite, ferrihydrite and goethite were observed during this process. When Fe2+ ions were absent during the reaction process, the final products had poor crystallinity and weak magnetic properties. While if only Fe2+ ions were used in the precursor, the sheet-like green rusts generated firstly, and Fe3O4 nanoparticles would gradually form on the surface of green rusts with the partial oxidation of Fe2+ ions. The results of regulating the reaction conditions especially reaction pH indicate that this reaction design can effectively reduce the formation of intermediate crystal phases.

Synthesis of Ultra-Fine Iron Powder by Combining the Flame Aerosol Synthesis and Postreduction

Controllable Synthesis of Hierarchical Micro/nano Structured FePO4 Particles under Synergistic Effects of Ultrasound Irradiation and Impinging Stream

Influence of Different Preparation Methods on Crystallisation and Morphology of Fe2o3 Nanoparticles

An Α-Fe2o3 Powder of Nanosized Particles Via Precursor Dispersion

New Sustainable, Scalable and One-Step Synthesis of Iron Oxide Nanoparticles by Ion Exchange Process

Preparation of Nanoparticles with an Environment-Friendly Approach

Preparation of FePO4 Nano-Particles by Coupling Fast Precipitation in Membrane Dispersion Microcontactor and Hydrothermal Treatment

Pilot-scale co-precipitation synthesis of a novel active ingredient made of ultrasmall iron (oxyhydr)oxide nanoparticles for the treatment of hyperphosphatemia

Ultrasonic-assisted Preparation of Monodisperse Iron Oxide Nanoparticles

Low-cost One-Pot Synthesis of Hydrophobic and Hydrophilic Monodispersed Iron Oxide Nanoparticles

Improvement on fluidization and reduction of ultrafine CuO powders with the assistance of iron microspheres

The Preparation of an Ultrafine Copper Powder by the Hydrogen Reduction of an Ultrafine Copper Oxide Powder and Reduction Kinetics

Aerosol synthesis of phase-controlled iron-graphene nanohybrids through FeOOH nanorod intermediates.

Flame synthesis of nanoparticles based on high flux electrostatic atomization burner

The coprecipitation formation study of iron oxide nanoparticles with the assist of a gas/liquid mixed phase fluidic reactor

A Simple Scalable Production Route for Superparamagnetic Ferrite Nanoparticles with Size and Shape Tuneability

Direct Precipitation for a Continuous Synthesis of Nanoiron Phosphate with High Purity

A Simple Solution Route to Control Synthesis of Fe3O4 Nanomaterials at Low Temperature and Their Magnetic Properties

Ultra-Large-Scale Synthesis of Fe3o4 Nanoparticles and Their Application for Direct Coal Liquefaction

Process Engineering to Increase the Layered Phase Concentration in the Immediate Products of Flame Spray Pyrolysis

Preparation of Gamma Iron Oxide Particulate by a Low Temperature Flux Method