Abstract:Ultra-high-performance seawater sea-sand concrete (UHPSSC) has attracted increasing attentions over the past few years as it exhibits exceptional mechanical and durability properties similar to conventional ultra-high-performance concrete (UHPC). Comparing to conventional UHPC, UHPSSC has great advantages when applied in marine engineering, particularly in offshore projects where construction materials are not easily accessible, and the transportation is costly. Nonetheless, current production of UHPSSC still necessitates large amounts of cement due to its low water/binder ratio. The larger demands of cement in manufacturing UHPSSC/UHPC than ordinary concrete can lead to substantial increase in the carbon emission. Therefore, an eco-friendly UHPSSC is developed in this paper by incorporating a promising ternary binder system (LC3) that consists of limestone (LS), calcined clay (metakaolin) and cement. The influence of the metakaolin (MK) dosage on the mechanical, hydration and microstructure properties of UHPSSC is comprehensively studied by carrying out a variety of experiments including mechanical test, isothermal conduction calorimetry test, TGA, XRD, SEM etc. The results showed that the UHPSSC mixed with LC3 exhibited lower early-age compressive strength than the reference mix, but its long-term strength was better than the reference group owing to the formation of more hydrates at the late age by the pozzolanic reaction of MK and the synergistic reaction between LS, MK and cement. Based on this study, the coupled replacement rate of cement by LS and MK could reach up to 40% without strength compromise. Nonetheless, 20% MK and 10% LS appeared to be the optimum substitution rate (total substitution rate of 30%) where the highest long-term strength was achieved. The main exothermic peak and total heat of hydration normalized per binder weight decreased with the increase of MK content level, but the main peak occurred earlier. Moreover, the addition of seawater can promote the hydration, leading to a greater main exothermic peak.

Workability, strength, and shrinkage of ultra-high-performance seawater, sea sand concrete with different OPC replacement ratios

Development of Sustainable Self-Compacting Concrete Using Recycled Concrete Aggregate and Fly Ash, Slag, Silica Fume

Mechanical properties and hydration of ultra-high-performance seawater sea-sand concrete (UHPSSC) with limestone calcined clay cement (LC3)

Effects of w/b ratio, fly ash, limestone calcined clay, seawater and sea-sand on workability, mechanical properties, drying shrinkage behavior and micro-structural characteristics of concrete

Sulphate Corrosion Mechanism of Ultra-High-Performance Concrete (UHPC) Prepared with Seawater and Sea Sand

Developing a Sustainable Ultrahigh-Performance Concrete Using Seawater and Sea Sand in Combination with Superfine Stainless Wires

Investigating the effects of seawater and sea sand aggregates and supplementary cementitious materials on the early shrinkage and crack resistance of concrete

Efficient Utilization of Waste Marine Clay for Fine Aggregate to Develop Sustainable and Cost-Effective Strain-Hardening Cement-Based Composites

Evaluating mechanical, microstructural and durability performance of seawater sea sand concrete modified with silica fume

Effect of modified supplementary cementitious material on performance of mortar and concrete in marine environment

Performance of High-Strength Concrete with the Effects of Seashell Powder as Binder Replacement and Waste Glass Powder as Fine Aggregate

Experimental study on strength and abrasion-resistance enhancement admixture

Sustainable ultra-high performance concrete with incorporating mineral admixtures: Workability, mechanical property and durability under freeze-thaw cycles

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Comprehensive evaluation of early-age hydration and compressive strength development in seawater-mixed binary and ternary cementitious systems

Study of the influence of seawater and sea sand on the mechanical and microstructural properties of concrete

The Mechanism of Anticorrosion Performance and Mechanical Property Differences between Seawater Sea-Sand and Freshwater River-Sand Ultra-High-Performance Polymer Cement Mortar (UHPC)

Mock-up pragmatic study on the impact performance of self-compacting concrete incorporating sea sand

Capillary water absorption and free shrinkage characterization for seawater sea-sand concrete

Early crack resistance and life cycle assessment of seawater-mixed sintered sludge cement paste

Research on the performance of seawater sea-sand concrete: A review