Abstract:Abstract In a data center, electronic equipment such as server and switches dissipate heat and the corresponding cooling systems contribute to typically 25–35% of total energy consumption. The heat load continues to increase as there is a greater need for miniaturization and convergence. In 2014, data centers in the U.S. consumed an estimated 70 billion kWh, representing about 1.8% of total U.S. electricity consumption. Based on current trend estimates, U.S. data centers are projected to consume approximately 73 billion kWh in 2020 [1]. Many research and strategies are adopted to minimize energy cost. The recommended dry bulb temperature for long-term operation and reliability for air cooling is between 18–27°C and the largest allowable inlet temperature range to operate at is between 5°C and 45°C with American Society of Heating, Refrigeration, and Air-Conditioning Engineers (ASHRAE) enabling much broader allowable zones) [2]. But understanding a proper cooling system is very important especially for thermal management of IT equipment with high heat loads such as 1U or 2U multi-core, high-end servers and blade servers which provide more computing per watt. Many problems like high inlet temperature due to the mixing of hot air with cold air, local hot spots, lower system reliability, increased failure, and downtime may occur. Among many other approaches to managing high-density racks, in-row coolers are used in between racks to provide cold air and minimize local hot spots. This paper describes a computational study being performed by applying in-row coolers for different rack power configuration with and without aisle containment. The power, as well as the number of racks, are varied to study the effect of raised inlet temperature for the IT equipment in a Computational Fluid Dynamics (CFD) model developed in 6SigmaRoom with the help of built-in library items. A comparative analysis is also performed for a typical small-sized non-raised facility to investigate the efficacy and limitations of in-row coolers in thermal management of IT equipment with variation in rack heat load and containment. Several other aspects like a parametric study of variable opening areas of duct between racks and in-row coolers, the variation of operating flow rate and failure scenarios are also studied to find proper flow distribution, uniformity of outlet temperature and predict better performance, energy savings and reliability. The results are presented for general guidance for flexible and quick installation and safe operation of in-row coolers to improve thermal efficiency.

CFD Modeling of the Distribution of Airborne Particulate Contaminants Inside Data Center Hardware

A Cfd-Based Test Method For Control Of Indoor Environment In Air-Conditioned Rooms

Analytical Modeling of Forced-Air Cooling Heatsink by Considering Air Temperature Rise in Channel and Coupling of Multiple Heat Sources

An open-source and experimentally guided CFD strategy for predicting air distribution in data centers with air-cooling

Innovative approaches of experimentally guided CFD modeling for data centers

Simulation study on Air Outlet of Data Center

Three computational methods for analysing thermal airflow distributions in the cooling of data centres

Comparison of detached eddy simulation and standard k—ε RANS model for rack-level airflow analysis inside a data center

Guidance for data-center CFD (RP-1675)

A Simulation-Based Approach to Data Center Thermal Efficiency Optimization

A hybrid lumped capacitance-CFD model for the simulation of data center transients

Development and validation of an open-source CFD model for the efficiency assessment of data centers

Optimal Design and Modeling of Server Cabinets With In-Row Coolers and Air Conditioning Units in a Modular Data Center

CFD modeling of airborne pathogen transmission of COVID-19 in confined spaces under different ventilation strategies

CFD Modeling of Pressure Drop through an OCP Server for Data Center Applications

A parametric CFD study of computer room air handling bypass in air-cooled data centers

CFD boundary conditions for contaminant dispersion, heat transfer and airflow simulations around human occupants in indoor environments

BIM and Computational Fluid Dynamics Analysis for Thermal Management Improvement in Data Centres

Numerical study of fluid flow and temperature distributions in a data center

The Numerical Simulation of the Airflow Distribution and Energy Efficiency in Data Centers with Three Types of Aisle Layout

CFD Investigation of Ventilation Strategies to Remove Contaminants from a Hospital Room