Abstract:Abstract In a data center, electronic equipment such as server and switches dissipate heat and the corresponding cooling systems contribute to typically 25–35% of total energy consumption. The heat load continues to increase as there is a greater need for miniaturization and convergence. In 2014, data centers in the U.S. consumed an estimated 70 billion kWh, representing about 1.8% of total U.S. electricity consumption. Based on current trend estimates, U.S. data centers are projected to consume approximately 73 billion kWh in 2020 [1]. Many research and strategies are adopted to minimize energy cost. The recommended dry bulb temperature for long-term operation and reliability for air cooling is between 18–27°C and the largest allowable inlet temperature range to operate at is between 5°C and 45°C with American Society of Heating, Refrigeration, and Air-Conditioning Engineers (ASHRAE) enabling much broader allowable zones) [2]. But understanding a proper cooling system is very important especially for thermal management of IT equipment with high heat loads such as 1U or 2U multi-core, high-end servers and blade servers which provide more computing per watt. Many problems like high inlet temperature due to the mixing of hot air with cold air, local hot spots, lower system reliability, increased failure, and downtime may occur. Among many other approaches to managing high-density racks, in-row coolers are used in between racks to provide cold air and minimize local hot spots. This paper describes a computational study being performed by applying in-row coolers for different rack power configuration with and without aisle containment. The power, as well as the number of racks, are varied to study the effect of raised inlet temperature for the IT equipment in a Computational Fluid Dynamics (CFD) model developed in 6SigmaRoom with the help of built-in library items. A comparative analysis is also performed for a typical small-sized non-raised facility to investigate the efficacy and limitations of in-row coolers in thermal management of IT equipment with variation in rack heat load and containment. Several other aspects like a parametric study of variable opening areas of duct between racks and in-row coolers, the variation of operating flow rate and failure scenarios are also studied to find proper flow distribution, uniformity of outlet temperature and predict better performance, energy savings and reliability. The results are presented for general guidance for flexible and quick installation and safe operation of in-row coolers to improve thermal efficiency.

The Numerical Simulation of the Airflow Distribution and Energy Efficiency in Data Centers with Three Types of Aisle Layout

Simulation study on Air Outlet of Data Center

Numerical study of fluid flow and temperature distributions in a data center

A Thermal Environmental Analysis Method for Data Centers

A Simulation-Based Approach to Data Center Thermal Efficiency Optimization

Influence of floor air supply methods and geometric parameters on thermal performance of data centers

An open-source and experimentally guided CFD strategy for predicting air distribution in data centers with air-cooling

Three computational methods for analysing thermal airflow distributions in the cooling of data centres

Simulation and experimental research on the optimization of airflow organization and energy saving in data centers using air deflectors

Effect of uneven heat load on the airflow uniformity and thermal performance in a small-scale data center

Performance Comparison Between Data Centers with Different Airflow Management Technologies

Study of hot air recirculation and thermal management in data centers by using temperature rise distribution

Optimal Design and Modeling of Server Cabinets With In-Row Coolers and Air Conditioning Units in a Modular Data Center

BIM and Computational Fluid Dynamics Analysis for Thermal Management Improvement in Data Centres

Experimental Investigation on Ducted Hot Aisle Containment System for Racks Cooling of Data Center

Numerical Simulation of Solar Chimney-Based Direct Airside Free Cooling System for Green Data Centers

Investigation Of The Mechanism Of Temperature Rise In A Data Center With Cold Aisle Containment

Optimization of airflow organization in fan-wall data center via baffles

Optimization air-conditioning system and thermal management of data center via fan-wall free cooling technology

Study of CFD-Based Raised-Floor Data Center Cooling With Parametric CRAC Turbofan Blower Airflow Patterns

An energy-environment coupled simulation framework for multi-scale and multi-facet evaluation of data center