Abstract:AbstractTo investigate the differences of mechanical behaviour and pore evolution characteristics of new solidified borehole-sealing materials, traditional triaxial compression tests, Brazilian splitting test and nuclear magnetic resonance test were conducted to analyse the deformation, strength characteristics and pore evolution characteristics of three types of sealing materials under different confining pressures. The results are as follows: the improvement of elastic modulus and deformation modulus of borehole-sealing materials under the influence of confining pressure is proportional to the elastic modulus and deformation modulus at a low confining pressure. There is little difference in the cohesion among the three types of sealing materials and the differences in the strength thereof are caused by the difference in the internal friction angle. The influence coefficients of confining pressure show a negative exponential decreasing trend with increasing confining pressure. When the confining pressure is 3 MPa, turning points appear in the plot of confining pressure coefficient versus confining pressure. The ratio of tensile strength to uniaxial compressive strength of the sealing material is between 9.2 and 15.2%. The T2 spectra of the internal pore-fracture system of the three types of borehole-sealing materials all exhibit a three-peak distribution, in which the proportion of adsorption pores is the highest, and the proportion of seepage pores and fractures is relatively small. Under different confining pressures, the stress sensitivity of different pore structure types in the new solidified sealing material is all lower than that of traditional sealing materials and cement mortar. This study on mechanical behaviour and pore evolution of those samples was conducted to facilitate the knowledge of different sealing material performance, and to deliver practical meanings on the progress and development of borehole-sealing technology.

Effect of optimized pore structure on sealing performance of drilling sealing materials in coal mine

Effect of nano-SiO2/styrene-acrylic emulsion on compactness and strength of mine drilling seal materials

Relationship between pore structure and mechanical properties of bituminous coal under sub-critical and super-critical CO2 treatment

Study on the Mechanics and Pore Characteristics of Coal Seam Drilling Sealing Materials Based on Nanomaterial Optimization.

Development and performance testing of the new sealing material for gas drainage drilling in coal mine

Experimental Study on the Optimization of Polymer-Modified Cement-Based Composite Sealing Materials and Mechanical Properties and Permeability of Cemented Coal Bodies

Development and performance optimization of a new composite sealing material prepared by drilling cuttings

Experimental study comparing the microscopic properties of a new borehole sealing material with ordinary cement grout

Microscopic properties and sealing performance of new gas drainage drilling sealing material

Preparation of a New Borehole Sealing Material of Coal Seam Water Infusion

Investigation on microscopic pore structure optimization and Lattice Boltzmann seepage law in coal modified by N -methylpyrrolidone composite solvents

Effect of polyvinyl alcohol/aluminum microcapsule expansion agent on porosity and strength of cement-based drilling sealing material

Experimental Research on Performance of New Gas Drainage Borehole Sealing Material with High Fluidity

Study on the Effect of Drilling Fluid on Pore Throat of Coal Bed

Synergetic Effect Of Ternary Mixture Of Nano Silicon Carbide-Polyvinyl Alcohol-Lithium Sulfate On Early Strength Of Cement

Experimental Investigation of Cement-Based Sealing Materials for Degasification Using Coal-Bed Methane Drainage System

Experimental study on mechanical behaviour and pore evolution of borehole-sealing materials under different confining pressures

Performance and application of new inorganic retarding sealing material suitable for multi-scale fractures

Study on the mechanical properties and microstructure of a rich-watered grouting material

A study on the impact of ultrasonic-stimulated clean fracturing fluid on the pore structure of medium to high rank coal

Micro-nano-scale pore stimulation of coalbed methane reservoirs caused by hydraulic fracturing experiments