Abstract:Oil well cement paste is a key structural component in wells that should provide mechanical support to the casing and prevent uncontrolled flow of formation fluids along the wellbore and to the environment. Since the annular cement paste is subjected to both hydrostatic pressure and to loads from formation or through the casing, it is important to understand the mechanical behavior and strength of oil well cement pastes under confining conditions. We study cement specimens cored from test sections that were cemented using a full-scale batch mixer. The specimens were tested mechanically without confinement and under 10, 20 and 40 MPa confining pressures using a state of the art triaxial test system. Unconfined samples are found to exhibit linear elastic behavior up to axial strains of approximately 0.2% with an average Young’s modulus of 14.9 GPa and a Poisson ratio of 0.21. At larger strains, the stress–strain response deviates from the initial slope, terminating with a brittle shear failure at axial strains of approximately 0.5%. The corresponding average uniaxial compressive strength is 58 MPa, in good agreement with previously published results. When subjected to confining pressures of 10 MPa or higher, the cement paste accommodated larger strains at a given level of deviatoric stress, and maintained its load-carrying capacity through the entire test cycle. The Young’s modulus for the initial loading phase was found to decrease with increasing confining pressures, and the ultimate deviatoric stress approached approximately 80 MPa, independent of the magnitude of the confining pressures used in this study. The results suggest that the main effect of increasing confining pressure is to increase the sample ductility and the axial strain corresponding to the ultimate deviatoric stress. It is further found that the confined stress–strain behavior of the oil well cement paste can be described by a simple nonlinear constitutive equation. The more ductile and flexible response of well cement under relevant confining pressures is considered to be a positive characteristic of cement as a barrier material for zonal isolation. This study is based on a commercial well cement slurry that is mixed and placed using field equipment. The results are therefore considered novel and unique, and can contribute toward improved knowledge and evaluation of mechanical well cement behavior under realistic, confined conditions.

Experimental study on mechanical behaviour and pore evolution of borehole-sealing materials under different confining pressures

BEHAVIOR OF PORE WATER PRESSURE IN DYNAMIC TRIAXIAL TESTS OF SATURATED SOFT CLAY AND ITS EFFECT ON EFFECTIVE STRESS PATH

Experimental study of novel high pressure resistant borehole sealing method

Experimental study comparing the microscopic properties of a new borehole sealing material with ordinary cement grout

Effects of cyclic confining pressure on permanent deformation of saturated soft clay

A laboratory study of the effect of confining pressure on permeable property in soil-rock mixture

Mechanical behavior and constitutive model of lining concrete in triaxial compression infiltration process under pore water pressure

Numerical Study on the Shear Strength of Granular Materials under the Low Confining Pressure

Effect of optimized pore structure on sealing performance of drilling sealing materials in coal mine

Experimental Research on Performance of New Gas Drainage Borehole Sealing Material with High Fluidity

Experimental study on seepage evolution and microscopic characteristics of initially damaged concrete under variable confining pressure

Experimental Study on the Optimization of Polymer-Modified Cement-Based Composite Sealing Materials and Mechanical Properties and Permeability of Cemented Coal Bodies

Preparation of a New Borehole Sealing Material of Coal Seam Water Infusion

Mechanism of permeability evolution under stress-seepage coupling in concrete for drilling shaft lining of water-rich weakly cemented formations

Laboratory investigations on failure, energy and permeability evolution of fissured rock-like materials under seepage pressures

Influence of testing temperature and pressure on the mechanical behavior of well cementing materials

Effects of confinement pressure on the mechanical behavior of an oil well cement paste

Research on mechanical properties of weak expansive soil under conditions of different confining pressures and moisture contents based on triaxial test

Experimental Investigation on Permeability Evolution of Dolomite Caprock under Triaxial Compression

Experimental investigation of rigid confinement effects of radial strain on dynamic mechanical properties and failure modes of concrete

Comparative analysis of sealing effect of different hole sealing processes in coal mine