Abstract:Abstract In this study, a high-throughput fabrication method called laser-assisted direct roller imprinting (LADRI) was developed to lower the cost of nanoimprinting large-area polymer films and to address problems associated with nanoimprinting, namely, microstructural damage and precision in flatness of entire film. With LADRI, the laser directly heats the microstructured surface of the roller mold, which heats and melts the surface of a polymethyl methacrylate (PMMA) film to replicate the microstructures on the mold rapidly. In this study, the effects of laser power density, scanning speed, size of the microstructures, and contact pressure on the replication speed were investigated experimentally. The replication speed increased as the power and scanning speed increased. However, because the film required heating until it filled the entire depth of the microstructure, an appropriate replication speed was necessary. This result was supported by simulation of the temperature distribution inside the mold and the PMMA using transient heat conduction analyses. To demonstrate the applications of LADRI, two different optical surfaces were replicated: an antireflection (AR) structure with conical structures sized several hundred nanometers and a light-extraction structure with a microlens array (MLA) comprising 10 μm lenses, for display and illumination, respectively. The replication degree of the MLA was governed by the contact pressure. Polymer flow simulation indicated that the heat conduction and flow speeds of the melted PMMA surface were comparable within several tens of micrometers. In addition, the reflectivity of the AR structure decreased from 4 to 0.5%, and the light intensity of the light-extraction structure increased by a factor of 1.47.

Theoretical and experimental investigation of an ultrathin optical polymer light guide plate during continuous injection direct rolling

Research on Continuous Injection Direct Rolling Process for PMMA Optical Plate

Continuous injection direct rolling for optical elements with microstructures

A Framework of a Continuous Injection Direct Rolling Process for Precision Manufacturing Plastic Plates with Patterned Microstructures

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

The use of roll-to-plate UV-curing embossing to produce a composite light guide plate

The Interface Thermal Resistance Evolution between Carbide-Bonded Graphene Coating and Polymer in Rapid Molding for Microlens Array

Experimental Study on the Fabrication of the Light Guide Plate with Hot Embossing Method

Experimental Research on CO_2 Laser Direct-writing Machining PMMA Microchannel

Research on the multilayer injection molding of thick-walled polymer optical products

Printing Depth Modeling, Printing Process Quantification and Quick-Decision of Printing Parameters in Micro-Vat Polymerization

Simulation and Experimental Study on Enhancing Dimensional Accuracy of Polycarbonate Light Guides

Analysis of Melt Front Behavior of a Light Guiding Plate during the Filling Phase of Micro-Injection Molding

Laser-assisted direct roller imprinting of large-area microstructured optical surfaces

In situ X-ray diffraction and thermal simulation of material extrusion additive manufacturing of polymer

Investigating gradient temperature control for enhanced interfacial bonding behavior in material extrusion 3D printing continuous fiber reinforced polymer composites

Research and application of surface heat treatment for CO2 continuous laser ablation of polymeric methyl methacrylate materials

Investigation of Interface Thermal Resistance between Polymer and Mold Insert in Micro-Injection Molding by Non-Equilibrium Molecular Dynamics

Characterization of process and machine dynamics on the precision replication of microlens arrays using microinjection moulding

Roll-to-plate micro-imprinting of large-area surface micro features: Experiments and a local simulation method

Injection-rolling nozzle flow channel design and optimisation in polymer continuous injection direct rolling processes