Abstract:This experiment used a magnetic concentrator and multi‐stage power control to improve the temperature uniformity of a mobile vacuum imprinting platform. The feasibility of large‐area imprinting was achieved. Hot embossing is a low‐cost and flexible method for fabricating microstructures and nanostructures on polymers. However, the conventional hot embossing process poses two challenges: First, the plates that are used do not provide uniform pressure, and the size of the chamber limits the imprinting area. Second, heating with thick metal plates significantly lengthens cycle time. Finally, the uniformity of temperature also affects the embossing results. To achieve a high heating rate and uniform pressure over a large area, this study combined an induction heating system and roll‐to‐plate hot embossing. A movable plate was used to move the mold through the induction coil, increasing the heating area and overcoming limitations related to the embossing area posed by the coil length. The imprinting area reached 100 × 100 mm2. In addition, the temperature difference was less than 20°C at each molding temperature range from 150°C to 190°C. The mold and the substrate were placed on a vacuum absorber to prevent deformation and slippage of the mold and provide preloading and packing pressure. Cooling fans were employed to improve cooling efficiency. Experimental replication yielded replication rates higher than 97% at 190°C and 5 kgf/cm2 with a cycle time of approximately 2 minutes. To verify the feasibility of the process, V‐groove microstructures were successfully fabricated using a movable induction heating roller embossing facility. Highlights The feasibility of the moving induction heating roller embossing process. A vacuum movable platform prevents deformation and slippage of the substrate. Improve the temperature uniformity of the movable platform.

Roll-to-plate micro-imprinting of large-area surface micro features: Experiments and a local simulation method

Investigation on the roll-to-plate microforming of riblet features with the consideration of grain size effect

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

An experimental study on a rapid micro imprinting process

A Framework of a Continuous Injection Direct Rolling Process for Precision Manufacturing Plastic Plates with Patterned Microstructures

Replication of large‐area microstructures by combining movable induction heating and roller hot embossing

A novel macro-micro integrated incremental sheet forming process for fabricating parts with functional surface microfeatures

Experimental investigation for roll-to-plate embossing of ordered micro-pyramid array on the silver sheet

Theoretical and numerical investigation of micro-textures fabrication by ultrasonic surface rolling process

Analysis and Optimization of Tooth Shapes of Roll Stampers for Optical Micro-Structured Array Imprinting

Effect of multi-point roller dies on the forming accuracy of profile in flexible 3D stretch bending technology

Study on Polymer Flow Profile in Micro Hot Embossing

Study on multi-roller flow forming process of aluminum alloy cylinders with cross ribs

Development and Research Application of Optical Waveguide Microstructure Component Manufacturing Process for Triangle Roller Imprinting

Near-perfect replication on amorphous alloys through active force modulation based on machine learning/neural network parameter prediction

Investigation of hot roller embossing for microfluidic devices

On-Machine Measurementand Characterization of V-Groove Structure Pattern on Precision Rollers

Forming characteristics and mechanism of double-roll rotary forging for large-diameter and thin-walled metal discs

Fabrication and evaluation of complicated microstructures on cylindrical surface

Research on the Micro Sheet Stamping Process Using Plasticine as Soft Punch

Ultra-precision machining of polygonal Fresnel lens on roller mold