The Interface Thermal Resistance Evolution between Carbide-Bonded Graphene Coating and Polymer in Rapid Molding for Microlens Array

Xiaohua Liu,Cheng Guo,Yandong Liu,Feng Wang,Yanfeng Feng

DOI: https://doi.org/10.3390/polym13142334

IF: 5

2021-07-16

Polymers

Abstract:Surface rapid heating process is an efficient and green method for large-volume production of polymer optics by adopting 3D graphene network coated silicon molds with high thermal conductivity. Nevertheless, the heat transfer mechanism including the interface thermal resistance evolution between 3D graphene network coating and polymer has not been thoroughly revealed. In this study, the interface thermal resistance model was established by simplifying the contact situation between the coating and polymethylmethacrylate (PMMA), and then embedding into the finite element method (FEM) model to study the temperature variations of PMMA in surface rapid heating process. Heating experiments for graphene network were then carried out under different currents to provide the initial heat for heat transfer model. In addition, residual stress of the PMMA lens undergoing the non-uniform thermal history during molding was presented by the simulation model together. Finally, the optimal molding parameters including heating time and pressure will be determined according to calculation results of the interface thermal resistance model and microlens array molding experiment was conducted to illustrate that the interface thermal resistance model can predict the temperature of the polymer to achieve a better filling of microlens array with smooth surface and satisfactory optical performance.

polymer science

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the evolution mechanism of the interfacial thermal resistance between the carbide - bonded graphene coating and the polymer during the rapid prototyping process of the microlens array. Specifically, the researchers focus on how to establish an interfacial thermal resistance model to describe and predict the changes in the contact situation between the 3D graphene network coating and polymethyl methacrylate (PMMA) and the evolution of the interfacial thermal resistance during the rapid surface heating process. This problem is of great significance for optimizing the manufacturing parameters of the microlens array and improving its geometric shape and optical performance.

The paper mentions that the traditional precision molding process includes four steps: heating, pressurizing, slowly cooling to medium temperature, and rapidly cooling to room temperature. However, this process is time - consuming, especially in the heating and cooling stages, due to the time consumption caused by the non - contact heating method and the large heat capacity of the entire system. Therefore, the researchers proposed a rapid molding method of contact heating to solve this problem, and studied the heating characteristics of the graphene network under different currents and the influence of these heating characteristics on the temperature distribution of PMMA through experiments and finite - element simulation (FEM). In addition, the imbalance problem of the residual stress inside the polymer block caused by non - uniform heating was also explored.

Through this research, the author hopes to determine the optimal molding parameters (such as heating time and pressure), and verify through the rapid molding experiment of the microlens array that the proposed interfacial thermal resistance model can accurately predict the temperature of the polymer, so as to achieve a better filling effect of the microlens array, with a smooth surface and satisfactory optical performance.