Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. Heat affected zone on the micromachined material, a hindrance in achieving good precision and accuracy, which are adequate requirements for micromachined materials, is a drawback of nanosecond micromachining assisted by laser. The primary objective of this paper is to take into consideration a number of input parameters, such as the pulse width and the temperature of the laser beam, and study the effect that these parameters have on the heat flux generated as well as on the temperature distribution along the square grooves of 200 μm width and depth that are to be micro-machined on an alumina ceramic workpiece. However, processing of alumina ceramic on a micron-scale requires careful consideration to raise the quality standard. This will be accomplished by analyzing the data collected from the micro-machining process. Using the ANSYS® software, it is possible to visualize not only the region where heat is generated but also the way in which the input parameters influence the structural qualities of the micro machined groove surface. The many thermal models that have been constructed have revealed specific changes in the structural qualities that have had a significant impact on the upper width, the lower width, and the depth of the groove when applied to a variety of different parametric settings. Finally, developed analytical model is compared with the experimental models. The highest prediction error was found to be 1.68%, while, for constant 50 W power and 150–250 mm/s of speed, the average prediction error was determined to be 1.18%. As a result, the proposed model closely matches the experimental findings, and the proposed model can be used to estimate channel profile.

3d Finite Element Modeling Of Laser Machining Pmma

Dynamic Interface for Three-Dimensional Transient Laser Ablation Polymer Microchannels

Transient Ablation Model for Laser Machining Polymer Microfluidic Chip

Simulation of 3d Chip Shaping of Aluminum Alloy 7075 in Milling Processes

Finite Element Simulation and Analysis of Aluminum Alloy Three-Dimensional Milling

Experimental Research on CO_2 Laser Direct-writing Machining PMMA Microchannel

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Investigations of the Laser Ablation Mechanism of PMMA Microchannels Using Single-Pass and Multi-Pass Laser Scans

Thermo-Fluid-Dynamic Modeling of the Melt Pool During Selective Laser Melting for AZ91D Magnesium Alloy

Factor Analysis of Machining Parameters of Fiber-Reinforced Polymer Composites Based on Finite Element Simulation with Experimental Investigation

Numerical Simulation and Validation of Multiscale 3D Laser Spiral Machining of Microholes

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Femtosecond Laser Micro-Machining of Three-Dimensional Surface Profiles on Flat Single Crystal Sapphire

Research and application of surface heat treatment for CO2 continuous laser ablation of polymeric methyl methacrylate materials

Study on the influence of Fs-laser power on the entrance morphology of vessel microfluidic chips

Computational approach for structural and thermal behavior of laser-machined micro-grooves on alumina ceramic using ANSYS

The Interface Thermal Resistance Evolution between Carbide-Bonded Graphene Coating and Polymer in Rapid Molding for Microlens Array

System Design For Laser Assisted Milling Of Complex Parts

Preparation of high-quality three-dimensional microstructures on polymethyl methacrylate surfaces by femtosecond laser micromachining and thermal-induced micro-leveling

Optimizing laser-based micro-cutting for PMMA microfluidic device fabrication: thermal analysis and parameter optimization