Abstract:<p>Single crystal Si is a typical infrared optical material, which is widely used in infrared optical systems such as lenses, prisms, windows and filters. But its high brittleness, hardness, and low fracture toughness make it difficult to machine using conventional machining (CM). Laser-assisted machining (LAM) method has become a promising solution for the machining of single crystal Si in recent years. This paper investigated experimentally the effect of spindle speed, feed speed, cutting depth, and laser pulse duty cycle on the surface roughness during the LAM of single crystal Si based on the Taguchi method (TM) and Response surface methodology (RSM). Orthogonal array and Box-Behnken design were used to design the experiment. Analysis of variance, signal-to-noise ratio, main effect plots, 3D response surface, and corresponding contour plots were measured to evaluate the effect of factors on the surface roughness. Based on RSM, a regression model between process parameters and surface roughness was established. The experimental results on LAM demonstrated a considerable improvement in the machinability of single crystal Si through the improved surface quality, high material removal rate, as well as the surface roughness reduction, compared to CM. The contribution rates of spindle speed, feed speed, cutting depth and pulse duty cycle to surface roughness were 21.85%, 39.95%, 10.29% and 14.27%, respectively. According to the 3D response surface, the interaction between different factors had a significant effect on the surface roughness. ANOVA and response optimization were employed to find optimal machining conditions for LAM. Finally, the Optimal parametric combination was as following: a spindle speed of 4000 rpm, a feed speed of 2 mm/min, a cutting depth of 5.86 μm, and a pulse duty cycle of 27.60%. The maximum value of measured roughness was 1.9 nm.</p>

Femtosecond Laser Micro-Machining of Three-Dimensional Surface Profiles on Flat Single Crystal Sapphire

Optimization of the Femtosecond Laser Machining Process for Single Crystal Diamond Using Response Surface Methodology

Prediction Model for Liquid-Assisted Femtosecond Laser Micro Milling of Quartz without Taper

Optimization of multistage femtosecond laser drilling process using machine learning coupled with molecular dynamics

Experimental and Simulation Research on Femtosecond Laser Induced Controllable Morphology of Monocrystalline SiC

Experimental investigations on the laser-assisted machining of single crystal Si for optimal machining

A Method for Preparing Surface Sub-Microstructures on Sapphire Surfaces Using Femtosecond Laser Processing Technology

Experimental investigation and optimization of femtosecond laser processing parameters of silicon carbide–based on response surface methodology

Single-pulse femtosecond laser ablation of monocrystalline silicon: A modeling and experimental study

Laser-Induced Cavitation-Assisted True 3D Nano-Sculpturing of Hard Materials

3d Finite Element Modeling Of Laser Machining Pmma

Thermal analysis of in-situ laser assisted diamond cutting of fused silica and process optimization

Surface modeling and component analysis of picosecond laser ablation of CVD diamond

Investigation on sapphire ablation by femtosecond-nanosecond dual beam laser

Numerical Simulation and Validation of Multiscale 3D Laser Spiral Machining of Microholes

Accelerating ultrashort pulse laser micromachining process comprehensive optimization using a machine learning cycle design strategy integrated with a physical model

Exploring Machine Learning and Machine Vision in Femtosecond Laser Machining

Study for Laser Controlled Fabrication of Micro/Nano-Structures of Silicon Based on Multi-Physics Model

Sub-diffraction-limit fabrication of sapphire by femtosecond laser direct writing

Machine learning-driven process of alumina ceramics laser machining

Modeling and optimizing of laser-assisted waterjet process parameters for near-damage-free micromachining of monocrystalline silicon