Abstract:Oxy-coal combustion has great potential as one of the major CO2 capture technologies for power generation from coal. In oxy-coal combustion, the oxygen source is a high concentration oxygen stream and the product flue gas consists primarily of CO2 and H2O with contaminants like nitrogen oxides (NOX), sulfur oxides (SOX) and non-condensable gases like argon, oxygen and nitrogen. NOX and SOX removal can be achieved via traditional selective catalytic reduction (SCR) and flue gas desulfurization (FGD). These traditional methods however result in relatively high capital cost and energy requirement and face complex material handling challenges. White et al. proposed a different approach to NOX/SOX removal based on the nitric acid and lead-chamber chemistry process (White et al., 2010). This two-column design utilizes an intermediate and a high-pressure reactive absorption column connected in series to respectively remove SOX and NOX from the high CO2-concentration flue gas. In this study, we propose a modification to this two-column process that achieves the complete removal of SOX and NOX from the CO2 stream in a single column. We demonstrate by means of pressure sensitivity studies that this new design can meet the same separation targets as the two-column process in fewer column stages and half the feed water requirement by exploiting the pressure dependence of the rate determining NO oxidation reaction. Furthermore, we make use of parametric studies to analyze the dependence of NOX/SOX removal on key design and operating parameters for the proposed system: pressure, vapor hold-upper stage and water flow rate. Results show that the process is strongly pressure dependent, with a 3-order of magnitude decrease in required residence time when the operating pressure is varied from 4bars to 30bars. Vapor holdup volume and feed water flow rate have a significant impact on NOX/SOX removal up to a point – about 20m3 and 2kg/s respectively for the case analyzed. Beyond these values, column performance shows substantially less sensitivity to increasing holdup volume or water flow rate. The analysis presented in this paper also shows that recycling bottoms liquid can reduce the feed water requirement by up to 40% without significantly affecting the exit gas purity.

A Simple Mathematical Model and Computer Simulation of Non-isothermal Gas Absorption in Packed Tower

Measurement and Modeling of Nitrogen Oxides Absorption in a Pressurized Reactor Relevant to CO2 Compression and Purification Process

Experimental Study and Rate-Based Modeling on Combined CO2 and SO2 Absorption Using Aqueous NH3 in Packed Column

Numerical Simulations of CO2 Absorption by MgO-based Sorbent in a Gas–solid Fluidized Bed

Numerical Simulation of No2 Absorption Using Sodium Sulfite in A Spray Tower

Simulation of Capturing Carbon Dioxide from Flue Gas by Activated Carbon

Dynamic modelling and simulation of a post-combustion CO2 capture process for coal-fired power plants

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

Modeling and Economic Analysis on Combined Capture of CO2 and SO2 in Flue Gas Using Aqueous Ammonia

Gas-phase Simulation of Oxyfuel-Derived CO2 During Sour Compression Process

Kinetics of NOx absorption into (NH4) 2SO3 solution in an ammonia-based wet flue gas desulfurization process

Modeling and experimental studies on chemical absorption of sulphur dioxide with ethylenediamine-phosphoric acid solution in a θ-ring packed tower for purification of flue gas

CFD investigation of post-combustion CO 2 capture using an industrial spray tower: Regulation effects of spray schemes

Modeling Solid-Liquid Equilibrium of the NH3-CO2-SO2-K2SO4-H2O System and Its Application to Combined Capture of CO2 and SO2 Using Aqueous Ammonia

Pilot-Scale Experimental Study on the CO2 Capture Process with Existing of SO2: Degradation, Reaction Rate, and Mass Transfer

Modeling and parametric analysis of nitrogen and sulfur oxide removal from oxy-combustion flue gas using a single column absorber

Kinetics of simultaneous desulfurization (SO2) and denitrification (NOx) by biofilm-packing tower

Simulation of CO 2 capture process in gas-solid bubbling fluidized bed by computational mass transfer

Mathematical modelling of carbon capture in a packed column by adsorption

Numerical simulation on adsorption of CO2 using K2CO3 particles in the bubbling fluidized bed

Modeling and Experimental Study of Oxygen Absorption in Sulfite Solution with Fine Particles