Abstract:This work investigates the compositional dependence and thermal annealing of the morphological properties, electrical conductivity mechanisms and Mott's parameters of sprayed MoxW1-xO3 (x = 0, 0.05, 0.10 and 0,20) thin films. The prepared thin films were examined using field emission scanning electron microscopy (FE-SEM), energy dispersive X-ray analysis (EDX) and Fourier transform infrared spectroscopy (FTIR) techniques. In addition, the two-point probe method was used to calculate the electrical properties of MoxW1-xO3 thin films. The FTIR results revealed that; the tungsten hydroxyl bond (W-OH) and the surface hydroxyl group vibrated within the ranges of 1558.62-1645.56 cm-1 and, 3296.76 and 3424.34 cm-1, respectively. Furthermore, a prominent band in the spectrum spanning from 850 to 650 cm-1 represents the W-O-W bridge mode. The FE-SEM investigations found that the molybdenum (Mo) dopant caused significant changes in the surface morphology of the films. The EDX results showed that the percentages of the isotropic elements MoxW1-xO3 agreed well with those obtained by atomic weight. Studies of the conduction mechanism indicate that the transition temperature was approximately 393K. Corresponding to Mott's model, the conduction mechanism below this temperature was across the variable hopping conduction band near the Fermi level. The mechanism exhibited a cycle of localised states through activated thermionic emission above 393K. Mott parameters were also estimated in addition to barrier potential energies, trapping state energies, local state densities, and other variables. The results revealed that both temperature areas had a rise in ρo and ρ1 values during and after annealing. The ΔEo and ΔE1 values in each temperature area decreased as the Mo-ion concentration increased. Furthermore, the conversion temperature gradually reduced as Mo was added. Based on these properties, the study's overall findings indicate that MoxW1-xO3 is suitable for future photonic devices and optoelectronic applications.

Structural, Morphological, and Optical Characterization of MoO3 Thin Films and MoO3/p-Si Based Diode

Investigation in Feasibility of Molybdenum As A Back Contact Layer for Silicon Based Quantum Dot Solar Cells

Structural, optical, and electrical properties of spray-pyrolyzed MoO3 thin films by varying precursor molarity, as hole-selective contact for silicon-based heterojunction devices

Role of thermal heat-treatment to achieve a highly polycrystalline and compact α-MoO3 thin films

Impact of Mo+2 addition and thermal annealing on the surface morphology, electrical transport properties and Mott's parameters of WO3 films for potential photonic devices

Thermionic Emission of Atomic Layer Deposited MoO3/Si UV Photodetectors

Study on structural and optical properties of thermally evaporated MoO3 thin films

Magnetic, Optical and I-V Characteristics of MoO3 thin films

Interface study of molybdenum oxide thin films on n- and p-type crystalline silicon surface

Effect of post-annealing on the properties of thermally evaporated molybdenum oxide films: Interdependence of work function and oxygen to molybdenum ratio

Effect of annealing temperature on the structure and electrochromic properties of MoO3 thin films

Temperature-dependent Optical Properties of Low-Loss Plasmonic SrMoO3 Thin Films

Tuning of physical properties in MoO3 thin films deposited by DC sputtering

MoO3 with the Synergistic Effect of Sulfur Doping and Oxygen Vacancies: The Influence of S Doping on the Structure, Morphology, and Optoelectronic Properties

Electrochemical and electrochromic properties of MoO3 thin film

Atomic Layer Deposition and Post-Growth Thermal Annealing of Ultrathin MoO3 Layers on Silicon Substrates: Formation of Surface Nanostructures

Optical, Optoelectronic, and Third‐Order Nonlinear Photonics of Ultrathin Molybdenum oxide Film Deposited by Atomic Layer Deposition

Vapor growth and photoconductive property of single-crystalline MoO 3 nanosheets

Post-annealing Effect on Optical and Electronic Properties of Thermally Evaporated MoOX Thin Films as Hole-Selective Contacts for p-Si Solar Cells

Properties of MoO3 Films Deposited by Electron Beam Evaporation

Mn-doped molybdenum trioxide for photocatalysis and solar cell applications