Abstract:Based on the Zhoushan alternating current (AC) 500kV cross-linked polyethylene (XLPE) submarine cable project, a method of metal sheath grounding via a low resistor, a low reactor, or a low resistor in parallel with a reactor at both terminals of the cable to reduce the power loss has been proposed in this paper. By numerically modeling the submarine cable system with the PSCAD/EMTDC software, the voltage and current distributions, and power loss on the sheath, armor and total submarine cable under three types of grounding impedors are calculated. The results show that with the increase of resistance value or inductance value, the sheath current decreases, and the armor current and sheath voltage increase, but the overall loss of the submarine cable decreases. When the submarine cable is operating under normal, short-circuit or transient conditions, in which the sheath voltage does not exceed the critical condition of these allowable values, the way that the sheath is grounded via a low resistor is the most beneficial to the power loss reduction. When the corresponding critical resistance value is 2.1 ohms at the start of cable and 1.3 ohms at the end respectively, it will reduce the power loss of cable for one phase 23.5% and the total power loss including resistors for one phase 14.2%, which is conducive to improving both the safety and operation economy of submarine cable.

Simulation analysis of metal sheath and Armor loss of DC submarine cable based on COMSOL

An Investigation on Grounding System of AC Single-core Submarine Cable Based on Multi-conductor Analysis Theory

Investigation on Loss Reduction Strategies of Single-Core HVAC Submarine Cables

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

Optimizing Grounding System Design and Loss Reduction Measures Analysis for Submarine Cable Landing Section

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Fatigue Failure Analysis and Simulation Calculation of Submarine Suspended Pipelines

Performance of Different Grounding Systems of 500 Kv XLPE Long Submarine Cables Based on Improved Multiconductor Analysis Method

Transient Performance of Loss Reduction Strategy for Power Cables Installed on the Bridge

Analysis of Thermo-electric Coupled Simulation for 10 Kv AC XLPE Cable under Different DC Topologies and Laying Modes

Characteristic Analysis of the Outer Sheath Circulating Current in a Single-Core AC Submarine Cable System

Research on Anchor Damage and Protection of Three-Core Composite Submarine Cable Considering Impact Angle

Field Test and Numerical Modeling of Submarine Photoelectric Composite Cable under Anchor Impact

Electrothermal Coupling Analysis of Submarine Cables

Research on the Optimization of Grounding Methods and Power Loss Reduction Based on AC 500kv XLPE Submarine Cable Project

Cable Sheath Loss Analysis Based on Coupled Line Model

Dynamic Analysis of Submarine Cable During the Process of Laying Back to the Seabed

Damage assessment for submarine photoelectric composite cable under anchor impact

A Novel Grounding Mode for Enhancing Current Rating of AC Submarine Cables

Simulation Analysis of Burial Depth State of Optical Fiber Composite Submarine Cable Based on Temperature Field Variation

Mechanical Responses of Submarine Power Cables Subject to Axisymmetric Loadings