Abstract:For single-core cables widely used in high or super-high power systems, induction voltage will cause circulating current flowing in the loop of the cable sheaths and the earth or the reflux wires. This current will produce additional losses, so as to reduce the current capacity of the cables, and the grounding wire will be burnt out when the heating effect is serious. Analyses on the circulating current in cable systems have been reported in some documents, but they are only for single circuit networks. In recent years however, two- and three-circuit cable networks are increasingly applied in cities, so accordingly the determination of the circulating current in these arrangements causes much attention. Thus the research work is focused on the calculation method for circulating current of a two-circuit cable network in linear arrangement. What presented first is the equivalent circuit for the circulating current calculation. Then the equations to calculate the circulating current in metal sheaths of two-circuit arranged cables are deduced and the basic principles of the solution program for this specific issue are provided. After parameter values are assigned according to the lay and operation condition of cables in two-circuit arrangement of a power designing institute, the circulating current in cross-bonded cable sheaths in linear arrangement are calculated. According to the calculation results, the analyses on influencing factors are carried out, and some possible ways to reduce the circulating currents are presented, such as to increase the earth resistance, to lay cables closely, and to make the cable length of every cross-interconnect segment equal. Besides, results from the single-circuit linear arrangement are also provided, for the comparison to be made with the two-circuit one. It is shown that two-circuit arrangement cannot be simplified as single-circuit when calculating circulating currents in cable sheaths. Although the calculation equations and the solution program in this paper are specially for the two-circuit linear-arranged cable networks, the technique for equation deduction and program design can be extended to cables in other lay conditions of two-circuit arrangement or even more circuit number.

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

Optimizing Grounding System Design and Loss Reduction Measures Analysis for Submarine Cable Landing Section

An Investigation on Grounding System of AC Single-core Submarine Cable Based on Multi-conductor Analysis Theory

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Performance of Different Grounding Systems of 500 Kv XLPE Long Submarine Cables Based on Improved Multiconductor Analysis Method

Investigation on Loss Reduction Strategies of Single-Core HVAC Submarine Cables

Investigation on Circulation Current Calculation and Grounding Methods of Multi-circuit Cables

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Transient Performance of Loss Reduction Strategy for Power Cables Installed on the Bridge

Research on the Optimization of Grounding Methods and Power Loss Reduction Based on AC 500kv XLPE Submarine Cable Project

Simulation Analysis of Grounding Characteristics of Cable Based on ATP-EMTP

Fault current calculation and grounding scattering optimization of 220 kV tunnel cable systems

Characteristics and Reduction of Sheath Circulating Currents in Underground Power Cable Systems

Cable Sheath Loss Reduction Strategy Research Based on the Coupled Line Model

Cable Sheath Loss Analysis Based on Coupled Line Model

A Novel Grounding Mode for Enhancing Current Rating of AC Submarine Cables

110Kv High Voltage Cable Sheath Transposition to Reduce the Grounding Induction Currents

Comparison of Methods for Suppressing Circulating Current in Metal Sheath of Cables Connected in Parallel

Calculation of Circulating Current in Sheaths of Two-circuit Arranged Cables and Analyses of Influencing Factors