Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Transient Performance of Loss Reduction Strategy for Power Cables Installed on the Bridge

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Investigation on Loss Reduction Strategies of Single-Core HVAC Submarine Cables

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

Experimental study on cable-truss reinforced structure system under heavy load

An Investigation on Grounding System of AC Single-core Submarine Cable Based on Multi-conductor Analysis Theory

Optimizing Grounding System Design and Loss Reduction Measures Analysis for Submarine Cable Landing Section

Flashover Discharge Model of Transmission Lines in Subsea Observation Network

Corrosion-Fatigue Analysis of Wires in Bridge Cables Considering Time-Dependent Electrochemical Corrosion Process

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

Simulation and Analysis of Lightning Overvoltage of 10 kV Cable on the Bridge of High-speed Railroad

Cable Sheath Loss Reduction Strategy Research Based on the Coupled Line Model

Simulating Calculations of Transient Voltages and Insulation Coordination on 500 Kv AC XLPE Submarine Cable Line

Research on the Optimization of Grounding Methods and Power Loss Reduction Based on AC 500kv XLPE Submarine Cable Project

Static Performance of a Long-Span Concrete Cable-Stayed Bridge Subjected to Multiple-Cable Loss during Construction

Simulation Calculation of Transient Voltages on Insulation and Sheath Along 500kV XLPE Submarine Cable

Performance Variations of A Cable-Stayed Bridge with Damaged Cables

Structural performance degradation of cable-stayed bridges subjected to cable damage: model test and theoretical prediction