Abstract:High-speed, pressure-compensated variable displacement piston pumps are widely used in aircraft hydraulic systems for their high power density. The swash plate is controlled by the pressure-compensated valve, which uses pressure feedback so that the instantaneous output flow of the pump is exactly enough to maintain a presetting pressure. The oscillation of the swash plate is one of the major excitation sources in the high-speed piston pump, which may cause lower efficiency, shorter service life, and even serious damage. This paper presents an improved model to investigate the influence of the variable displacement mechanism on the swash plate oscillation and introduces some feasible ways to reduce oscillation of the swash plate. Most of the variable structural parameters of the variable displacement mechanism are taken into consideration, and their influences on swash plate oscillation are discussed in detail. The influence of the load pipe on the oscillation of the swash plate is considered in the improved model. A test rig is built and similarities between the experiments and simulated results prove that the simulation model can effectively predict the variable displacement mechanism state. The simulation results show that increasing the volume of the outlet chamber, the spring stiffness of the control valve, the action area of the actuator piston, and offset distance of the actuator piston can significantly reduce the oscillation amplitude of the swash plate. Furthermore, reducing the diameter of the control valve spool and the dead volume of the actuator piston chamber can also have a positive effect on oscillation amplitude reduction.

Investigating the Effect of Valve Shape on Anti-Lock Braking System Plunger Pump Performance Using Fluid-Structure Interaction Simulation

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

Simulation and Experimental Investigation on Pressure Dynamics of Pneumatic High-Speed On/off Valves

An Experimental Study on Hysteresis Characteristics of a Pneumatic Braking System for a Multi-Axle Heavy Vehicle in Emergency Braking Situations

Comparing research on two different numerical models of electrostatically actuated valveless micropump

Flow characteristics simulation and low-noise design of fuel piston pump

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Comparative Study on Asymmetric and Symmetric Configurations of Valve Plates in Axial Piston Pumps

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Fluid Dynamics Investigation on the Body Structure Inside a Sleeve Regulating Valve

A research on the flow characteristics of ABS hydraulic control unit under switch control mode

Comfort Analysis on Anti-Lock Braking System Based on High-Speed Switch Valve

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

An Investigation into the Swash Plate Vibration and Pressure Pulsation of Piston Pumps Based on Full Fluid-Structure Interactions

Design of Pilot-Assisted Load Control Valve for Proportional Flow Control and Fast Opening Performance Based on Dynamics Modeling

Efficiency enhancement of bicycle anti-lock braking systems (ABS): Design and optimization of solenoid actuators through finite element analysis and performance simulation

Analysis of the Cylinder Block Tilting Inertia Moment and Its Effect on the Performance of High-Speed Electro-Hydrostatic Actuator Pumps of Aircraft

Simulation of ABS Hydraulic System and Optimization of Solenoid Valve

Low Leakage and High Volumetric Efficiency Research of Seawater Plunger Pump

Numerical Study on Sealing Performance after Wear of Plug Valve During Opening–closing Process

FSI FEA SIMULATION OF LIQUID-SUPPLEMENT VALVES IN GAS-PRESSURIZED HYDRAULIC DAMPERS