Abstract:ABSTRACT:The ventilation cooling system of large vertical hydro-generator is of great significance to its safe and stable operation, and it is very necessary to study on the flow field characteristics of the generator closed-circuit ventilation system. At present, due to the structural complexity of the stator ventilating ducts in generator, full port modeling simulation needs large amount of calculation, which brings certain difficulties to the numerical study on the full port flow field. This paper proposes a method to study the circulating flow field by modeling the minimal periodic unit, and adopts the multiple reference frame coordinates, as well as porous media model of cooler in CFX software during the numerical calculation. The calculation results show that air flow rate of ventilating ducts is small at the generator neutral position, so a method of increasing the cross-sectional area is recommended to improve the uniformity of the stator ventilation. The flow field of the section at yoke ventilating duct entrance presents certain inhomogeneity, which proves that it is not accurate to set boundary condition in the local modeling calculation. There is disadvantageous vortex in the flow field of the generator end. This paper further sets the transition arc plates at the generator end to achieve the results of disadvantageous vortex eliminated and the air flow rate increased by 15.3% compared with the original design. The research results can provide reference for the optimization design of the generator ventilation system.

CFD simulation and investigation on flow field characteristics and temperature predictions of an electric generator unit

CFD Calculation and Analysis of Cooling Jacket Flow and Heat Transfer for Car Engine

The Numerical Analysis Of Ventilation And Temperature Fields For A Bulb Tubular Turbine Generator

Ventilation and Stator Temperature Field of Bulb Tubular Turbine Generator

3D Thermal Analysis of a Permanent Magnet Motor with Cooling Fans

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

Study of Different Cooling Structures on the Thermal Status of an Internal Combustion Engine

Improving Combined Flow and Thermal Network Accuracy for Radially Air-Cooled Generators by Considering the Nonlinear Resistance Characteristics of T-Junction Flow

Numerical study of flow and heat transfer on construction machinery detached vehicular cooling system

Simulation and Experimental Study on Thermal State of Engine Compartment of Commercial Vehicle

Optimization of Motor Heat Dissipation Systems Based on Three Dimensional Flow Field Analysis

Numerical Simulation on the Flow and Temperature Field in the High-Power Motor

CFD Simulation of Flow Field,temperature Field and SO2 Absorption in Flue Gas Quench Tower

Three-Dimensional Computational Fluid Dynamics Modeling of a 6V150 Diesel Engine

Simulation and Test for the Thermal Behaviour of a Prototype Synchronous Generator with HTS Armature Windings

A Comparative Study on Coupled Fluid–Thermal Field of a Large Nuclear Turbine Generator with Radial and Composited Radial–Axial–Radial Ventilation Systems

Three-dimensional numerical simulation on thermal performance in counter flow natural draft cooling tower

Simulation Study on Closed-circuit Ventilation System of Large Vertical Hydraulic Turbine Generator

Influence of Complex Fluid Flow on Temperature Distribution in the Rotor Region of Large Hydrogenerator Under the Rotor Rotation

3D Temperature Evaluation of the Vane Based on Fluid-Network Method

Thermal Modeling and Experimental Validation in the Rotor Region of Hydrogenerator With Different Rotor Structures