Abstract:The accurate measurement on the compressibility and thermal expansion coefficients of density standard liquid at 2329kg/m3 (DSL-2329) plays an important role in the quality control for silicon single crystal manufacturing. A new method is developed based on hydrostatic suspension principle in order to determine the two coefficients with high measurement accuracy. Two silicon single crystal samples with known density are immersed into a sealed vessel full of DSL-2329. The density of liquid is adjusted with varying liquid temperature and static pressure, so that the hydrostatic suspension of two silicon single crystal samples is achieved. The compression and thermal expansion coefficients are then calculated by using the data of temperature and static pressure at the suspension state. One silicon single crystal sample can be suspended at different state, as long as the liquid temperature and static pressure function linearly according to a certain mathematical relationship. A hydrostatic suspension experimental system is devised with the maximal temperature control error ±50 μK; Silicon single crystal samples can be suspended by adapting the pressure following the PID method. By using the method based on hydrostatic suspension principle, the two key coefficients can be measured at the same time, and measurement precision can be improved due to avoiding the influence of liquid surface tension. This method was further validated experimentally, where the mixture of 1, 2, 3-tribromopropane and 1,2-dibromoethane is used as DSL-2329. The compressibility and thermal expansion coefficients were measured, as 8.5×10−4 K−1 and 5.4×1010 Pa−1, respectively.

The density of liquid silver from its melting point to its normal boiling point 2450°K

Density Equation for Saturated 3 He

Investigation on Liquid Density Data at the Bubble Point and Equations for the Refrigerant Hfc-404a over A Wide Temperature Range

Melting-Pressure And Density Equations Of He-3 At Temperatures From 0.001 To 30 K

Melting-pressure and Density Equations Ofhe3at Temperatures From0.001to30

Diffusivity of Liquid Mixture Confined in Silicate Pore by Molecular Dynamic Simulation

Reference Data for the Density and Viscosity of Liquid Antimony, Bismuth, Lead, Nickel and Silver

A practical density equation for saturated vapor of helium-3 from 0.01 K to the critical point

Molecular Dynamics Simulations on Specific Heat Capacity and Glass Transition Temperature of Liquid Silver

Reference Data for the Density and Viscosity of Liquid Cadmium, Cobalt, Gallium, Indium, Mercury, Silicon, Thallium, and Zinc

Density and Molar Volume of Liquid Amalgams of Thallium, Lead, and Bismuth

A Novel, Low-Cost and Robust Method for Determining Molten Salt Density at High Temperatures

Reference Data for the Density and Viscosity of Liquid Copper and Liquid Tin

Brillouin Scattering Studies Of Liquid Argon At High Temperatures And High Pressures

Density, Viscosity, and Surface Tension at 293.15 K and Liquid−Liquid Equilibria from 301.15 K to 363.15 K under Atmospheric Pressure for the Binary Mixture of Diethylene Glycol Diethyl Ether + Water

Chemical adsorption and temperature dependence of the solid-liquid interfacial tension of metallic binary alloys

Density and Thermal Expansion of Molten Manganese, Iron, Nickel, Copper, Aluminum and Tin by Means of the Gamma-Ray Attenuation Technique

Measurement Method of Compressibility and Thermal Expansion Coefficients for Density Standard Liquid at 2329 Kg/M(3) Based on Hydrostatic Suspension Principle

Measurement Method of Compressibility Coefficient for Density Standard Liquid at 2329 Kg/M(3) with A Vibrating Tube Densimeter

Liquid Density Measurement of N-Decane with a Random Temperature Signal Cross-Correlation Densimeter at High Temperatures and Pressures

Measurement Method of the Compression Coefficient of Near-Monocrystalline Silicon Density Liquid